60" QH Roller Project

[NHSleddog]

The content of this post has been edited to remove any possible offensive material. Sorry for the post.

If you would like information on this mod, send me a PM, I will be glad to provide it.

 

[Creature Meadow]

Looks nice, what do you intend to use it for?

 

[bird dogger]

NHSleddog, that turned out great! Wish I could find a pipe like that laying around. Your lawn roller would be perfect to help out with all the earthworms in my yard. The lawn gets pretty bumpy by the end of the season!!!

But will your roller push down all those New Hampshire rocks you were talking about??

david

 

[NHSleddog]

The content of this post has been edited to remove any possible offensive material. Sorry for the post.

Thank an offended member.

 

[NHSleddog]

......But will your roller push down all those New Hampshire rocks you were talking about??

david

Ummmmm, No.

LOL - A customer will ask "can you get that one out?", sorry mam, that one is NH it isn't going anywhere.

 

[Lil Foot]

Well done, and nice welds.

 

[Yooper]

Nice work! From looking at the pictures I do not see a gusset or strut from your bearings leg up to the forward main frame. I would encourage you to add them to strengthen up that area. If you did that already I apologize.

 

[NHSleddog]

The content of this post has been edited to remove any possible offensive material. Sorry for the post.

Thank an offended member.

 

[RCW]

Very nice indeed.

I mowed last night, and could use something like that for my lawn...holy smokes a few spots are rough.....

 

[Yooper]

There is a 6" 45deg gusset (2" angle) on the back on each side.

This is the weakest point in the design for sure but being 1/4" steel and full welds all around, it should be gtg.

Bingo! I could not see those in the pictures. Congratulations on a very nice build and enjoy the feeling of using something you made from scratch!

 

[GreensvilleJay]

nice but don't take sharp turns ! My 4' solid drum WILL dig into the tight corner....sigh, if I used it more I'd cut into 2 sections. lkie I 'need' another project.....