front pto shaft

B

Bo Jackson

New member

Equipment
1975 l225
Aug 31, 2014
7
0
0
Rayland Ohio USA
On the front off the engine on my 1975 l225 the pulley on the crank sticks out about 3 inches and is splined. Can I get a shaft that slips over that to drive something off of the front? I know it would run continual with the engine.
thanks
 
T

tcbro

New member

Equipment
L185, Woods L59 mower, rear blade, L-225, Kubota FEL
Mar 10, 2010
49
0
0
Coatesville, PA
On my L225 I run a hydraulic pump off of the front spline. It powers my FEL.
 
D

daniel.ray77

Member

Equipment
1976 Kubota L225DT
Nov 16, 2009
141
0
16
Salt Lake City, Utah
Hey TCBRO, does your front mount hydraulic pump flow more GPM than the factory pump? My FEL is hooked up to the factory pump but the cycle times for the loader are pretty slow and if you're doing repeatitive loader work it becomes quite annoying.
 
North Idaho Wolfman

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
30,188
6,360
113
Sandpoint, ID
daniel.ray77 said:
Hey TCBRO, does your front mount hydraulic pump flow more GPM than the factory pump? My FEL is hooked up to the factory pump but the cycle times for the loader are pretty slow and if you're doing repeatitive loader work it becomes quite annoying.
Click to expand...
Yes a front mounted pump will push more fluid and at a higher pressure than the old factory pump. ;)
 
T

tcbro

New member

Equipment
L185, Woods L59 mower, rear blade, L-225, Kubota FEL
Mar 10, 2010
49
0
0
Coatesville, PA
Yes, definitely. I think the factory pump only pushes about 2 gal/minute. The auxiliary pump is much higher. My FEL is fast, sometimes faster than me! My set-up also has a separate reservoir. It's on the right side, FEL frame up-right, under the control valves. It's a completely self contained system.
 

Attachments

You must log in or register to reply here.

Top Bottom