I have a Kubota model 175, very old model. The hydraulics work very slow after adding some fluid as it seemed very low. Can you add to much oil, or should it be drained and refilled
Thanks Bob
Thanks Bob
Bob 62
- Thread starter Bob62
- Start date
Daren Todd
Well-known member
Lifetime Member
Equipment
Massey Ferguson 1825E, Kubota Z121S, Box blade, Rotary Cutter
Theres a plug on the clutch side of the tranny. Should be orange. Thats the oil level indicator. Just fill oil till it starts to run out the hole. If your hydraulics are slow, i would check/clean the filter screen. Change the fluid if it hasn't been done recently. Could be a pin hole leak on the intake line to the hydraulic pump. Or it could be the hydraulic pump is getting weak.