Search results

Good day Dan, Thank you for your knowledge, I have resolved the issue and you were bang on with your advice. There is missing information on the Spool Valve Component Parts view. The washer that goes on detent shaft that is missing from the Component view. Thanks again, Great Forum!

I have tried adjusting the joystick linkage, but it didn't help! The joystick does have a little bit of play, but nothing near slopped out. I am going to pull it off this afternoon and take another look. Thank you for your help!

Thanks Dan! Your reply about excessive travel was my initial thought, but couldn't seem to find any answers to support it. I will take another deep dive into it and check it over again. Is there any manuals out there for the LA852 / Husco 9210 setup with tolerances? I have downloaded the parts...

Very good point! Do I invest the $600+ into the current valve and hope it works? I can't find any answers besides the explanation that Butch made way back 15 years ago about the spool being off tolerances. https://www.orangetractortalks.com/forums/threads/bazinga-i-got-it-fixed.1290/ I would...

Thanks Dan! I've already thrown $300 CAD at this one, for detent kit and seals spacers etc on the other end of the spool. The Husco 9210 has its known issues with water leaking into the detent. It would be silly now to send it to a machine shop to true the spool, when I can get a Summit Valve...

Thanks Butch, Yes, I did see them and was hoping for a different answer. I think the best solution for me is a better quality valve. Thank you for the explanation in your post, it was very helpful.

I am confused? "loader lifts with joy stick at at about 3/4 pull, lift stops when joy stick pulled all the way back." and was solved by a bad u joint on the PTO ?

Did you ever figure out the issue?

Did you ever figure it out?

Good day, I have a used MX5000 with a LA852-2 using a husco 9210 spool valve. The detent was not working, when cold the boom would not lower until warmed up. *(It was full of water and the balls/spring were sitting in the bottom cover) I noticed that in between float and down pressure, there was...