Search results

I have a chance to buy a Kubota BT602 Backhoe attachment. I have a kubota B1550 tractor which many of you have helped me get it running and it is running great THANKS FOR YOUR HELP. My concern is physical size and if the tractor has enough gpm. Not to concerned about mounting as I can modify if...

Amazon. So Im guessing thats my problem... Any idea that wont break the bank?

You guys helped me get this tractor running. It has been running pretty good. Now the problem I have is one injector stopped working, tried to bleed it and cant seem to get the air out, took the injector line off and have good fuel flow. I noticed if I put my finger over the injector fuel inlet...

It starts and runs great after help from you guys. Problem is at wot it is blowing blue smoke while under load. otherwise it is smoke free. crankcase vent is clear. No smoke or moisture coming out of the vent, Can hold my finger over the vent hole and feel pressure..... could valve seals cause...

Sorry for the delay, just been busy. yes fires right up with glow plugs. Thanks again. I do have a question. I have a bad head bolt D850. Do you happen know the bolt thread and size.?

Thanks motorhead. The heat gun did the trick.

Thanks I will give that a try and let you guys know

Thank you . Yes I have tried to start it. It does try with glow plugs but just cant seem to keep going. as far as i can tell the valves are right. I set them at .007 that is what i have read on google search. But that could be wrong

Kubota 1550 with a D850. I bought this non running, said it had been in a barn for a few years. cleaned the fuel system, lift pump, injection pump, new head gasket, new standard rings (liner walls seemed to be fine.). I getting 320 psi on each cylinder which was better than the 290 i was getting...

Thanks for you quick reply. You answered my question. Kinda already thought that. Just needed confirmation .. Thanks

I have a Kubota B1550 tractor. My question is. Do they make an in frame liner piston kit? What I find is semi finished liner piston kit. Do these have to go to a machine shop or can I hone them in frame after install. Thanks in advance .