Search results

It seems that my old Kubota L260 is so obsolete that parts are almost impossible to obtain. I have been told by several people that the best course for me is to re-assemble it as is and sell to a collector who will either have others available for parts, or have more spare time and resources to...

I'm up to my neck in alligators it seems.The crank either needs replaced or machined,(I'm thinking replaced so bearings don't have to be oversized),new rods,wrist pins,head gasket,head studs and nuts, searching the net for parts or whole engine.Call to local Kubota dealer gives news that crank...

It's a very used tractor I bought. I check the fluids religiously 'cause there are no functioning warning lights. I did replace the headlights , trees in the dark are very solid. It turns now with the head off. No resistance until the front piston is about 1/4 inch from the top,then a slight...

Finally got the head off.Pistons seem to be in place and in one piece.I'd be scratching the hair on top of my head in consternation except that there's nothing there to scratch.I'm guessing my next move will be to drop the pistons and see if the crank is snafued?

Vic, I was pulling a brush hog running 2000 in 2 high ,PTO at 4th. It started pulling hard. I raised the 3 point hitch thinking I was dragging. Still pulling hard. I kicked in the clutch,threw the PTO out of gear. The motor died. It's locked up tight.pulled the access on the bottom right after...

I'm about completely stumped. We took off all 9 nuts and the head won't budge. We tried to lift it with a come-a-long on an overhead beam and the whole front end started to lift. It's been soaking with penetrating oil around the studs for two days. The head still won't budge. If the gasket is...

removed everything except the studs from the head. head is still on the block. we have pried,tapped, and lifted but no seperation from block.do studs have to be double-nutted and removed also? any advice will be greatly appreciated.