Search results

OK i finally got WSM and read all of that and went through the adjustments and it said ok to everything but still throwing the error 61 code. I checked the ground wire and looked for a short in the harness as best I could without pulling it all out and didn't see anything. The connector are all...

OK well got the new alternator put on and it didn't fix the problems just my luck. Electrical is my weakest spot when it comes to working on things. It is throwing the first error 61 1 7 8 NG code which says solenoid 1 failure but I don't know what or which one is solenoid 1 and the solutions...

Well that would make sense. I checked the connections and they were all connected but when I went to start it the battery was dead. charged it up and tested it and it is good only 10 months old because I put it on when I took it to be fixed. So I took the alternator off and took it to the...

Give that man a cigar. You are a scholar and a gentleman sir. You were exactly right about the lines being switched. I looked and followed the diagram you sent and switched them around. Cranked it up and the 3 point hitch worked just like it should and so did the loader. The transmission still...

Thanks for that information I will check that when I get out of work today. Just wondering though wouldn't that make the loader not work right if a line were hooked up wrong because it is working like it should. It's the only thing that is. LOL

No he was not at the dealership. He is a local tractor mechanic that several farmers friends use and have used for several years but didn't work out for me. Yes it is a GST. That would make sense for the 3 point hitch, but wouldn't explain transmission issues I don't think. It will probably be...

Ok this has been a nightmare. My tractor was leaking fluid from around the drive shaft. I took it to a repair shop to be broken in half and a seal replaced as all the research I did said that was what needed to be done and the mechanic said the same thing. He had it for 10 months and I finally...

Thank you for the help. I should have given correct information to start with it's a GST not an HST L4630 but anyway. The information did help it was doing exactly that, a second after putting it in forward or reverse it would die. It was the safety switch under the seat. I was thrown by hearing...

Hey guys could use some help. I have a L4630 HST it starts and runs fine but when you put it in forward or reverse it dies. I think it probably a relay but not sure which one. I have a couple that I have changed behind the instrument cluster but didn't change anything. changed the fuel solenoid...