Search results

Thanks

Thanks very much for the part number. If you have an image of the parts drawing please send. Thanks again!

Thanks all,for the help so far on this B7100D restoration. After finally bleeding the fuel lines lines all three connections at the injector block leak at the base. Please review attached images and let me know if there is supposed to be an o-ring anywhere. I can only recall seeing a copper...

I am following the bleeding procedures for a B7100D after I replaced all fuel lines and injectors. I have been cranking this thing over in 10 sec increments many times and still do not see air bubbles or fuel exiting the air plug. Any tips on this is appreciated. Thanks !

I replaced just as I was restoring everything else. I pulled the hose from the pump and see fuel pushing so appears pump is working. I keep cranking it over to bleed the line with air plug open but yet to see fuel or air bub exit. I recently replaced the fuel lines and injectors. Any way to...

I installed a new fuel pump on a B7100D and it does not appear to be pumping. Any installation tips I may have missed? The new pump arrived with two paper baskets - one looking slightly thinner than the other and I installed one gasket. Not sure if that is a factor or not. Thanks!

I am looking for turf. - Thanks again

Orange motor heads, any luck in finding replacement front and rear wheels and tires for 80’s B7100D wheels and tires? Thanks in advance, WB.

Thanks squid! From Just a USMC Grunt 😁

After I removed my PTO shafts, later I found a spring type ring that does not appear to fit anywhere and wondering if it came from my 7100D PTO’s or from a previous project. Does anyone recognize this and know where it goes? thanks in advance. WB

Thanks!

Hello orange grease monkeys, I am replacing a few things and need torque specs for the following: 1) rear PTO plate 2) fuel injectors on motor 3) fuel injector connections on injection block 4) alternator nuts thanks in advance! WB