Search results

but wouldnt the voltage from the dyno feeding 30ish V AC into the regulator be enough to start the regulator?

It actually hasn't had a battery for about a year, Ive just been using my small lithium 12v jump starter to run it. It has two wires, im pretty sure its an older B7100.

ok thanks, I will check this out.

Hello, I have just tested the voltage from my battery leads whilst the tractor is running, without a battery connected and I got about 1.2V at full RPM. I tested the Dyno wires and I got the correct voltage in AC (I think up to 30V). I assume that I should be getting 12v feeding back to the...

yes sorry. Pipe realigned, new, longer bit of flexible fuel hose over the top, new hose clamps.

all fixed, thanks.

Yes the problem occured before I changed the fluid, filters etc. The pipe running to the oil cooler has a screen in it, so would this also be a suction pipe? I ask this because the flexible joiner (090) is in terrible condition and the hose clamps are ruined and do not tighten or loosen. The...

Hi, my mower has an air leak somewhere in the hydraulic system. It is causing foamy bubbly oil which is expanding and pouring our the breather. I have just changed the fluid, the filters and cleaned the screens but it did not fix the problem. My next guess is a loose connection somewhere...

thanks guys. Messicks says they are not allowed to post Kubota parts to Australia but I have an email from Kubota Australia saying the part is not available here so maybe Messicks will bend the rules for this one. Matt

or am I reading the diagram wrong and I need to buy part 020

Hi, I have an F2100 outfront mower with a RC60-F20R deck. The yoke that attaches to the gearbox has a worn internal spline and I was wondering where I could get a new one, perhaps aftermarket, as they dont seem to be available anymore. The best I have found is the entire PTO shaft which is...

Hi, I wanted to attach a gauge to check the hydraulic pressure on my B7100 HST because the 3pt lift doesn't lift like it used to. I just wanted to double check where the gauge connects to the machine. I have marked where I think it goes in the attached picture, is this correct?? I have a...