Search results

Wolfman, thankyou so much! I fired it up and drove it out of the garage. I put the loader back on. Hooked up the lines but now power steering is very hard to turn it was fine before the loader install. 3pt is working fine...you think the power steering cylinder is bad?

Thankyou Wolfman again for all the help...i took the line off the loader control with the male connectior and screwed the other end onto the fitting. (Photo attached) So i do not need to turn the slotted screw correct?

Wolfman, i turned the screw #1 in photo and fluid gushed out of #3 connector in photo. I turned the screw back and it quit gushing out. I cracked the nut on #2 line in photo and nothing came out??? So for some reason no flow in that line but turn it the other way and fluid gushes out of the...

Thanks Wolfman, this is what i have tried thus far. With the tractor running their is a fair sized bolt on top of the pump im guessing a kind of valve because it has a hole through it in which im guessing fluid to flow. I cracked that a little and fluid sprayed everywhere. I cracked the lines at...

Hi Bicman, i thought so too. But it does not seem to be pumping fluid...it was working fune before the tractor split....

Hi Wolfman, question for you. I got the engine all back together and started right up in about 5 secinds sounds good. However my power ateering, 3pt, or any htdraulics are working now. I bbn did remove several lines taking the tra tor apart but i checked and they all seem tight. I drained all...

Thankyou Wolfman!!

Absolutely Ironman2, you know yourself when you drill through something and their is a small space behind it you can feel it...i dont know but it could have been a lot worse as i feel blessed from the lord almighty that it wasnt. I just dont know what some are thinking tho...

Ok guys, a little follow up. Thanks Everyone again, for ideas. For lack of a good nickle welder, i did a small rubber plug and xold weld procedure. IRONMAN2, yes i would love to had that done but unaware of anyone around the area that does that kind of work. Overall im ok with the fix. I git it...

You guys are all great. I appreciate everyone lending their time to help a fellow out. Well my first choice would be a welder. Unfortunately i dont believe that is going to happen this time. Im one of those guys probably like a lot of you guys who will think of something no matter what tome is...

Wolfman and Rbargeron, thankyou. I missed it . The freeze plug behind the starter was new or fairly new. I popped that out and low and behold someone has drilled through. I think im safe tho, because the hole is only about an inch from the bottom of the sleeve so it should only be towards the...

I have a 1993 kubota L3650. I have already split the tractor and installed a new clutch. But have ran into an issue. I can not find a conclusive answer and i knew one of you guys would absolutely know. My number 2 cylinder has a small hole in the what looks to be a liner. So its leaking coolant...