Search results

Because I didn't have time to order new injectors, I decided to take the old kubota injectors apart. There was a carbon buildup on them all and one was a little wet I recall when I pulled them. I cleaned them up and took them apart. They cleaned up nicely and there was no pitting. I put them...

Got the new arm installed today. All is well.Again...thanks. But now I have a new issue. I also installed new fuel injectors and fuel filter this morning. I bled the lines and it's blowing white smoke and knocking. Research says it's probably a defective injector. Tomorrow, I'm going to...

Glad to hear that. I took the part in to the dealer yesterday and ordered part # 67950-36515. It cost $202.00. I'm just glad to get it straight again. Thanks all for helping. Wayne

Well....I got up this morning fully intent on drilling this roll pin out of the lift arm....but decided to give it one more try with the hammer. I resurfaced the face of my punch with a file and made sure it was just slightly smaller than the pin. I placed the punch on the pin and with a little...

Thanks Dave, I'll give it a try tomorrow and let you know how it goes. Wayne

I have soaked this roll pin in PB Blaster and have the correct size punch. It's not musroomng it and hitting it with a small sledge hammer. It's not budging. It's like it's a one way pin and I'm going the wrong way. I'm afraid if I hit it any harder I may damage something. Would it be best to...

Thank you! Yes, it looks like a roll pin. I have used the correct size punch and my BF hammer. I was hoping it wasn't a "one way" pin. I'll soak it good and let it sit overnight and try again tomorrow. Thanks again for the response. Also having a heck of a time finding a new arm from Kubota...

Hi All, New guy here from Maryland. I have a 23 year old Kubota B-1750HST 4 wheel drive tractor with a bent left side Hydraulic lift arm. I'm having a heck of a time getting the lift arm off the splined shaft. There is what appears to be a knock out pin on the back of the arm that needs to be...