Search results

I would try holding the clutch in & the keyswitch to the start position while moving the hi/low lever each way & then the fwd/rev pedal to neutral to see if the starter engages.I have seen one that would only start with the hi/low in neutral. Sent from my iPhone using Tapatalk

Thank you to all. I love my tractor but that stinkin leak drives me batty Sent from my iPhone using Tapatalk

My B2400 has a Woods 1006 and it works great Sent from my iPhone using Tapatalk

RTMach1, please share the kit part #. My B2400 will not stop leaking the oil out either. Both halves of the axle pivot housing have been replaced with new orings but it didnt stop the leak. Thanks! Sent from my iPhone using Tapatalk

RTMach1, please share the kit part #. My B2400 will not stop leaking the oil out either Sent from my iPhone using Tapatalk

I had a skidsteer and put a ratchet rake on it for specific uses. It worked great for a lot of tasks like clearing & removing brush..., levelling & grading dirt & gravel and was a very useful tool on a 7000lb machine. The way it is used, there is very little extension on the tilt cylinders when...

It will fit but may change the footprint/contact amount. I have a set of trencher tires that i believe are 10 ply on those rims. They footprint is slightly rounded but hasnt caused any issue, other than the tire guy cussing a lot to get it on Sent from my iPhone using Tapatalk

Unfortunately Texas is a long way from N Carolina. Not much $$available after paying taxes anyway right now. Any chance of getting pictures? Would love to see where the subframe mounts to the tractor. Sending you a pm Sent from my iPhone using Tapatalk

Ouch! I will likely have to get someone to fabricate a subframe, and buy a lift cylinder & control valve ... I would hate to think a drivetrain housing would be used as a mount for something like a blade. Seems like a recipe for a major repair with the potential pounding Sent from my iPhone...

I just picked up a 2020 blade(pic enclosed)with what i will call the hitch, which has the left & right angle cylinders. I do not have the lift cylinder & hoses or any of the subframe... Anybody have those items they would sell? Anybody have one they can measure lift cyl & mounts? I am hoping...

I have read about a lot of problems finding the tires, but what about just the rims? I just got a B2400 with 12” fronts & 33” rears. I have a good pair of 31” bar/turf that would need 10” fronts. Are the 10” rims available without good tires? Thanks. Sent from my iPhone using Tapatalk

I bought a NOS pair of the Bar Turf tires & rims from a Kubota dealer. I had talked to them on the phone and without a part # they had no idea what I was looking for. I stopped in a couple of days later with a picture of the bar/turf and the same guy said "we have a new set of those just been...

Glad you found them.

Berky, Have you found the rims you need yet? If not, are you just looking for rims or rims & tires?