Search results

BACK IN ACTION. She's back together and working great. Bought a new hsd from my local dealer (price is the same anywhere you try). It came in a few days later. Complete unit already assembled ( less a bearing and oil seal around the front output shaft) was easy to install. Definitely needed...

Just finished replacing my HSD. No instructions are available online. You might try and do what I did, which was to talk the service manager at the local dealer to let me borrow his service manual and run to FedEx/Kinkos. $10 later and you've got all the manual you'll need. You can split the...

WHAT A JOKE!? Kubota TOTALLY puts the shaft to you on parts. To replace the parts mentioned in my last post plus a couple other oddball seals, gaskets, and so on it would cost......drumroll please...........NEARLY $1,500.00!!!!! Not to mention paying a guy to reassemble the thing probably $100...

Well, we broke into the transmission and have found the problem. On the pump side cylinder block all the valves are rather worn on the ends and have developed a bit of a ridge on them. The bearing, washer, and swash plate are all either pitted or scratched. The cradle bearings for the swash...

Butch, FREAKING outstanding advice (the 7 p's). I'll be using that one at work man. Well, I have unfortunately narrowed it down to the internals. I'm bettin' on the swash plate being the culprit, but we'll see. I split the lil' booger apart on saturday afternoon. Not near as bad as I thought...

I'll be getting into it deeper this weekend. I'll let you all know the verdict. I've been making lots of calls and after much ado....it doesn't sound good. I'll keep you posted. Thanks for the help thus far.

As for noise, it just makes that good old hydro whine once forward motion becomes strained or stalled. And you are correct Kubotatech about the pressure check ports. They are very easy to access from underneath the tractor. There are three ports. The forward high pressure relief (left) the...

Ok. I have swapped out the forward/reverse high pressure relief valves to the opposite sides yet am getting the same result. Good reverse power, low forward power. Any further suggestions would be mucho appreciated. Thanks.

what do i need to do to check the relief pressure? I would prefer to fix it myself if possible.

Nope. No debris and the fluid that came out actually looked just fine.

Need some help here. I have a 1500 hour B2400 HST. Here is whats going on. All the hydraulic functions work perfectly including the FEL and the 3 point. In REVERSE the power is completely normal. Put it against a tree in reverse and she'll spin all four no problem. The problem is VERY LOW POWER...