Search results

Mike9, what does PSA stand for?

All, I am putting things back together, and I need some help on the "tape" under the hood. The tape Kubota describes as "Soft Tape Upper and Sides" makes sense as this is where the hood sits on the fuel tank, and a cushion is needed. But what are the other "tape" areas that Kubota simply...

Hi, No, I could never find them aftermarket. I wound up having to order through Kubota. Thanks, Jim

All, The muffler on my B6200D looks like it is made to support some sort of heat shield, but I can't seem to find any such item, or any reference to such an item. In picture 1 below you can see what I am talking about. This is a screen capture from YouTube, and the tractor is a B5100. The...

Success!!! Disassembled the injector, made sure beveled/mating surfaces were clean, and reassembled....no leaks. Thanks everyone for the help. Jim

OK....is that "dimple" a set screw?

An update (and more questions!) OK....I ordered the copper washers. I got six in case I had to take anything apart again. Basically what i did was pull them out, clean them up, clean the seats up, reassemble, and it all seemed to work except for the supply line leaked a little on the number...

Yep......Washed it, then for final cleaning before paint, used chemtool to clear away any gunk and oil. So...OK, I will order the copper washers. What about the one in back that appears to leak in the middle? If I split that, what goes in there as a seal? Thanks, Jim

Bump..because...well, because I desperately need some help. :)

Hi, I seem to be having a problem with leaky injectors. The attached photos show 1) All three injectors, 2) The rear injector, and 3) The front injector. The rear injector seems to be leaking in the middle (see red arrows). The front injector seems to be leaking from the joint at the head...

Glad you got it working. It was the same for me. I was convinced that the cable had broken, and the previous owner had done "something" to make it stick in place. But once I got some lubrication on it, it freed up.

Mike....See this thread. http://www.orangetractortalks.com/forums/showthread.php?t=22090

Mike, Review this thread. http://www.orangetractortalks.com/forums/showthread.php?t=21695 30" seemed to work fine for him. Jim

Not sure if it is right or not, but mine was stuck as well. I sprayed a little WD40 on the joint and it is now it is free and works just fine. I had to spray, work it a few times, and then spray again and work it a few times.

Hi, How did the scoop do? I assume you had it on your B7500. Did the 3Pt lift it high enough to dump? Thanks, Jim

I wanted to ask you about this, if there is more detail you can offer. I just had a 16X24 shed slab laid down, and while the plans I purchased talked about a base course, the guys laying the slab said no. They said raw undisturbed earth, and they ran over it repeatedly with their tractor...

Yes, perfect, thanks!

OK...so if I understand correctly, both the lower and upper race get seated into the lower steering box...? Does this mean the steering shaft becomes "trapped" between the two bearings? I am imagining you putting in the lower bearing, inserting the steering shaft, and then putting in the upper...

Could you please post pictures so future thread viewers can see the difference between the two?

Here is a little more detail. In Picture 1 I show that the oil seal and outer race were all mucked up, and I was convinced it was one piece. I had to dig the seal out. Once the seal was out, see picture 2, I bent a rod to the right angle, and was able to tap on the rod to get the bearing race...