Search results

I am trying to repair draft control on an m4500 that has been modified/hacked during a previous repair. I think the "lock bracket" is missing. It looks like it be a rectangular bar with a couple of holes and easy to fabricate if I had dimensions. Anyone willing to take measurements or post an...

Kinda stuck... I have the assembly removed from the tractor axle. #110, #150, and #140 are removed but cant figure what to do next. Can't seam to access to #80 and #100 ??? Any help would be appreciated. Jim

I am trying to replace the main bearing on my snowblower second stage and can't get it apart. I am assuming the inner race is just stuck on the shaft. I am going to go at it with a cutting torch if needed but I am wondering if anyone knows if something is else is holding it on?? Jim

Looking for advice on converting a front mount 63" B2782 to a 3 point. It was previously mounted on the front of a smaller tractor (B2650?). I will be using it on an L35. The BL2583 looks to be the factory conversion kit but I plan to make it myself. The info I have lists the B2650 "mid" PTO...

I just bought a 4500 with non-working hydraulics. 3 point lifts intermittent and real slow and the remotes (front forks) hardly move at all. I found the remnants of a gasket (see image) in the filter. It does not appear to have a pick-up screen. When I look into the fluid filll port I see a...

Hello, I am in search of words of wisdom on mounting a loader to an M4000. My questions are about the hydraulics. The tractor has a pump mounted on the side of the engine just aft of the fuel pump. it also has rear remote connections and even a control valve sort of below the seat. My...

Anyone know where I can buy weldable bushings? I plan to make a trenching fang for my L35 BT900.

Looking for advice on repair of my backhoe stabilizer control valve on an L35. The stab bleeds down in a few seconds. I believe the problem is in the "lock" valve portion of the control valve assembly. The valve assembly is a Husco 5000 F104C. I think the problem is in what they call the "pilot...

Does anyone know the "center of hole" to "center of hole" distance for lower arms for an L35? I believe it is the same as an L39 or L3940. Thanks, Jim