Search results

Ok thanks, I'll measure the amount that is drained and replace the same.

I am still not certain we a talking about the same compartment, I have found level plugs for the drive hubs on each front wheel, these are in behind the wheel rim. But I am after the oil level for the front differential (centre) section.

I am not sure what you mean, is there a level plug that I have missed somewhere?

I can not locate the level plug for the front diff oil on my L245DT. There is a plug on top of the axle housings either side, when removed, these only show the front drive axles (no dip sticks etc), I can feel the oil level by placing a small screwdriver down beside the axle shaft on each side...

L245DT Front Differential Oil I can not locate the level plug for the front diff oil on my L245DT. There is a plug on top of the axle housings either side, when removed these only show the front drive axles (no dip sticks etc), I can feel the oil level by placing a small screwdriver down beside...

G'day Stumpy, Although my L245 has a different thermostat housing you have given me the ideas on how to go about it. I will find a suitable location and make up a sender unit adaptor as you have done. Thanks very much for your help it is very much appreciated.

Your information is correct for my model tractor, there is not a pre-tapped port for a sender. It is difficult to install an off the shelve adaptor into the top radiator hose, because the 90 deg bend is too small and won't allow the standard type adaptors. I am planning to use an electric sender...

Hi, Has anyone installed a temp gauge into a L245DT Kubota engine? I'm a little old fashioned and like to watch the engine temp on hot summer days to ensure I'm not working the tractor too hard. Is there a place to install a sender unit or do you adapt it into the top radiator hose, if so how...

Thanks Guys, My Kubota has separate oil level plugs for each front drive hub which are OK (not filled from the front diff). The front diff has two filler plugs without dip sticks, one each side on the axle housings, I think a dip stick would foul the axle shaft. Maybe I just measure the...

Thanks Bulldog, my local dealer (in Sydney - Australia) just told me the same thing, don't use the final drive level plugs at all. Fill the trans to the side level plug, that is how they operate. One other question, the front diff has two filler plugs and a drain plug, is there a level plug (I...

Hi, I have a L245DT that is draining oil from the transmission into the LH gear case. Is it a difficult job to renew the seal between the compartments?