Search results

Our m9540d is running normal. Recently, I have noticed when I shut tractor off, I hear what sounds like a fan spinning down when you take power away. I have isolated it to the area of the turbo. This is a new sound and there is no apparent new noise when running tractor. Shut it off and you...

Now with literally freezing temperatures, putting the glass doors back on tractor has become a priority. I'm going to put the hinges, pull bar and latch with new rubber. I've been told horror stories about the glass shattering so I'm looking for advice or tips to get these doors assembled and...

Our m 9000 has developed an oil leak from the front crankshaft seal. It's pretty steady. Can anybody tell me if that seal can be replaced without removing front cover? I'm going to need a repair manual to do this job. Any recommendations? I'm unsure about these various online manuals...

I recently posted about a no start skid steer svl95-2s. Now we need to get it off jobsite and to dealer. Can this tracked vehicle be rolled when disabled...some way to disengage drive sprocket without disassembly?

2016 SVL 95-2s skid steer cranks but no start. Was running then quit. We changed fuel filter, drained old fuel and refilled with k own good diesel. We've purged the air procedure and all we are getting is crank, start for 4-5 seconds then it quits. This is an improvement, however, it just...

We have a newer m6060 that has the hydraulic block on rear for implement connection. We also have a m9000 with 2 of these blocks stacked on top of each other. The units look the same have same dimensions. Is there any reason why we can't take one of the blocks from the 9000 and stack it on...

M9540 has hydraulic leak from the output shaft at rear of tractor. I'm working on obtaining WSM but wanted to ask if that seal is serviceable without disassembling the entire tractor.

M 9000 rebuilt the forward reverse shifter and replace the ball shaped bearing on shifter shaft. Tilt steering column. The shift linkages are not properly adjusted. Can someone direct me to the procedure for adjusting? The adjusters are under floor plate.

My tractor and I, m9540, are out in a field with cube cart. The situation: start move forward and after say 30 seconds loses power. Stop and idles okay. Very little fuel in inline fuel filter. Shut off tractor fills up with fuel. Took off separator housing removed some trash at inlet elbow...

I'm new here but it's getting cold and the 2000 m9000 has no heat from vents. Where is the heater core located? Is there a inline shut off valve in these tractors as I have read about? Lastly, any special cooant refill procedure? Thank you in advance

my second attempt to post for help, first one disappeared..My m 9000 when put into forward pops out of gear when clutch is let out. If I hold the lever up it stays in gear and after clutch is released i can let go and it stays in gear. Stop and put into reverse with no issues. The lever has...