Search results

  1. Ikc1990

    Greetings from Berks County Pennsylvania's best kept secret

    Next test is battery connections all tight not corroded? Try putting pto to engage and then back sometimes I have to do that with my mid pto for my blower if it's not just right it's a no go lol. And if its bright day try ur hazzards. Just thoughts from the northern vt border lol
  2. Ikc1990

    Pallet Attachment

    Bmyers I agree and I am very grateful for what I have. I do make do with what I have when I can. And nothing wrong with it not to proud to have used or repair worn out not replace. That's how we survive.
  3. Ikc1990

    Pallet Attachment

    Some day I will have one or even QA forks until then it is me my handy short chain a hammer and the ole clamp on finger busting forks:( lol but better than no forks at all
  4. Ikc1990

    PVC mistakes... anyone else do this?

    I would leave it but if it is a glue. In. Filter how do you change or clean it cut it out each time? I'd . Find a different filter type or poput threaded end on each side and just glue adapters to the filter for easy maintenance. And just buy small tub to keep in a cool place stays longer...
  5. Ikc1990

    B2710 starting issue

    Yes that may have been part of the issue I changed the cables with pre crimped ends from a factory. Bought at auto parts store.
  6. Ikc1990

    B2710 starting issue

    I use it about 4 to 7 days a week but the previous owners put like 40 hrs on it in 2 years
  7. Ikc1990

    B2710 starting issue

    So this am I went out to get the kubota b2710 going first took terminals off cleaned, and took ground off frame cleaned that up and put back then cleaned up other end of power wire, tested battery and it had juice but not what I thought was great. So couple hundred bucks later I said screw it...
  8. Ikc1990

    What a difference a day makes

    My duramax had a 125000 mile emission warranty or 10 years whichever comes first.
  9. Ikc1990

    B2710 starting issue

    Will try that in the morning. Thanks
  10. Ikc1990

    B2710 starting issue

    So my b2710 is new to my earlier this fall. It is parked in an unheated hay barn. I am from northern vt. So this am I plugged my kubota in. Went to work knowing I needed to move tractor tonight for chores. Its around 8 deg out side. I unplugged tractor got in cab and it trys to turn over but...
  11. Ikc1990

    Generator Transfer Switch Setup, Better Late Than Never.

    This is what I have in house, barn and sugarhouse and had in mynold house too. Much cheaper than transfer switch box.
  12. Ikc1990

    Filter for BX series

    So I personally think changing the fuel filter is a routine maintenance key not only to keep crap out but it tells you alot about your fuel, and you tank and lines. Also the easyer it gosevthrough filter the less your pump is working to get it through the system. Just my thought. But its done on...
  13. Ikc1990

    Filter for BX series

    My duramax gets oil changed every 7500 miles and fuel and transmission filters every other oil change... so I do tractors the same yup probably could do less changes but in my eyes its cheaper to maintain than it is to replace or repair. Most times when there is a major breakdown it's due to...
  14. Ikc1990

    What did you do to or on your Kubota today?

    Nice job looks factory ! Good job
  15. Ikc1990

    What did you do to or on your Kubota today?

    Nice looking set up what are you building fence ?
  16. Ikc1990

    What did you do to or on your Kubota today?

    Well alot of cussing. Alot of learning how to use 3 for wooden dowels as chop sticks with duct tape on end after I drained the tank. Still was better than. My buddy's 70 horse massey Ferguson that we fished a dead mose out of fuel tank. After I tried sucking on fuel line to get sludge out. 🤢🤮🤮...
  17. Ikc1990

    New part for kubota b2710 fuel...

    Henry, I do to and I am so glad to have found this site I have learned a ton, but yet still have a lot to learn ran my tractor several hrs tonight fresh fuel fresh start. Ran great. Thought I'd share so if someone else had the issue it may help them. I like reading threads that start off...
  18. Ikc1990

    What did you do to or on your Kubota today?

    And hours and a nightmare later you get it removed.
  19. Ikc1990

    What did you do to or on your Kubota today?

    Yesterdays project with the wife any takes on where we found this?
  20. Ikc1990

    New part for kubota b2710 fuel...

    So I was cleaning our freestsall beef barn yesterday got 12 done and was going great had pushed some snow and was having a good day wife was helping me the beef were being pains in the butt but that's normal lol. I had run tractor for about 2 hrs and then I smelled really sooty diesel fumes. And...