Search results

Hi, I have a question regarding mower decks. I am thinking of buying a wider deck for my G1900 (18hp). A dealer told me that the rc60 would be too big and would require a tractor with about 30hp. The G1900 was offered with 48, 54 and 60" wide decks. So why would it suddenly be too weak? With...

Hello, I am a bit confused by the oil dip stick in the engine. It does not even look close to the picture in the manual. It is also fairly loose in the block, this could be wear or possibly it is the wrong dip stick. When I did an oil change today I filled in exactly 3l as per manual and now...

Hello, a newbie question regarding the cutting desk setup. It is an RC48-G20K which I believe is the wrong one for my tractor. I think it should be an RC48-G20K-S for four wheel steering. Somebody before had been very creative and cut off the front link and welded it together shorter. The rear...

Hello, as some may have read already in another thread I rescued a G1900 lawn tractor that, I believe, would otherwise have ended up in a scrap yard. The last few years it had been neglected and is in very poor condition. But short wiring the starter I could get it running and it started first...

Hello, I am looking for a faulty Kubota combination box, part number 66101-55920. I need the housing, cable and connectors. The electronics inside can be toast, does not matter. It is used in the G1700, G1800, G1900 and T1600 lawn tractors and I think some others too. Kind regards, Hugo

Hello, after trying my "new" G1900 (cut the grass at an unbelievable speed, delighted) it packed in with a burst water hose after just 10 minutes. Problems were expected and this is a different story anyway. I want to replace the paper thin fan belt. It is around the transmission drive shaft...

Hello, the battery cable on my G1900 is not routed correctly and I could not figure out how to route it from the starter to the battery avoiding sharp corners on the frame, the PTO pulley, the front axle and the hot exhaust. Also the fusible link seems to be missing. Could somebody please post...

Hello, I just registered on this forum. I will get a G1900 end of the week in pretty poor condition and huge hours on the clock and I plan to repair it and use it as the manufacturer intended. I found plenty of workshop manuals and spare parts lists on the internet but what I cannot find is a...