Search results

Done many Honda and clone honda motors ( over100). The e tube i talked about sometimes doesn’t come out easy. So most never clean it. If you set valves go .001 intake 002 on exhaust it will start very easy. I have modified the crap out of these motors for kart racing. Buy a carb and mess with...

Not loosing spark? No matter what its the carb …did you get the emulsion tube out and clean all the tiny holes. Newer carbs have passages that are almost impossible to clean. Try a ultrasound cleaner. Lately i just buy carbs for honda clones , stihl, Kawasaki others. Make sure valve lash is...

We have a bunch around here every night. But this guy came up and layed down watching us clean gutters. Too funny.

Buck decided to watch me clean gutters

Congratulations…. You take of it .. it will give you many years of service.

If you can get one direct replacement go for it. I use them in about everything i build here. From hot rods, street rods, race cars, tractors, big trucks. The ole wives tale that they dont cool as well is bs. I have never had one not do better or the same as copper. Most do much better...

😳

Drained cooling system and replaced with new coolant. Greased machine. Changed out summer air in tires to winter air. Quick nut and bolt. Don't own chains.

You very well could have. Its fuel correct? Doesn’t smell like gasoline? Cheap enough to drain and dump 2 gallon of fresh. Look to see color when you put it in can.

Absolutely need to do it with every trailer you buy. Even brand new i yank the drums and repack the bearings. Torque wheels and set tire pressures. Cheap insurance. 👍👍👍

. If you dont have a strap wrench an old belt that holds up your pants works. 🤣After 10 hours i would just punch the hole. Let it drain. Than push a big punch through. That doesn’t work just cut the can off and use a punch/ chisel on the seated flange of filter. It will come off. In the shop...

Drain some fuel in a glass bottle. Let it settle. Water maybe?

That’s probably any trailer. This brand has some seriously good welds… excellent powdercoating that even the big manufacturers of large trailers should be doing. A frame tongue not just a 2x2 neck.The wires are all run inside square tube frame. Its actually very well made. Carry on is the lower...

Was looking for a small utility trailer. I have larger 10k 22ft trailers but just wanted smaller for motorcycles or grabbing pellets. The 9x5.5 at tractor supply with fold down side rails , beaver tail tongue jack looked just what i wanted with out me building one. So off to tractor supply...

Many forget about using the lift arms to unload trailers and truck beds. Enjoy the lathe…. Now you need a bridge port. Even more bulky to move. 🤦‍♂️😆Used to load a 43 ft step deck with lathes and mills. Lots of chains an blocks 🤣

Little over a cord with what she put inside the circle.

Wife did the firewood deal. She saw a neighbor do it so she had to try. It dried out well. The other 6-7 cord is under the deck by walk out basement.

Yep the plate tamper a bit to small for that area. 4 hours with the roller . Be nice no mud anymore.

Yep this time of year a PITA. It’s covered now with vehicles and leaves 🤣