Search results

A fridge for beer. And a flasher instead of a bell for the phone.

Pieces of cardboard and thumb tacks worked for me to play with the geometry of a hydraulic actuator.

I think the bottom point closer to the tractor (when bucket is up, start of your video). This way you get a better angle when the bucket is fully tilted forward. Not too much though so that it does not affect the bucket up angle too much.

Move the cylinder attachment point.

Nice, polyurethane pallet truck wheels (y) Just bought a set for mine, they were falling apart.

Parts of those blocks look strange. Why would they cut a thread and then cut the block in half. wasn't an ordinary drill bit either ...

Won't help. With the paint fully scraped off they will claim abuse ... :)

To dig really fast, should they not be orange? :unsure:

Not sure if engine can be started (damage?) and how the forks are designed, but if you could put those down and tips slightly into the ground they could act as skids and take the weight of the front. If the forks can be lifted up by hand that would nor work, but maybe there is a way to tie them...

Hi, I got that from a parts diagram on messicks.com Kubota has similar parts catalogues online, but I cannot open them from my location. You say 240 is missing, but this is the bar you move in the video. Is that really spring loaded pushed downwards at the front? If yes, maybe the hooks are...

A friend of mine is plumber for the past 40 years. He tested all kinds of material for tapered thread gas pipes. After assembling them he opened the threads and re-tightened. The worst was Teflon tape, liquid sealers were kindof acceptable and by far the best was ..... drumroll here ..... hemp...

My thoughts: more surface area for clay / soil to stick to. If you have sandy soil this should not be a problem. Reinforcement on the outside would not have that disadvantage. And a nice round shape has a lot of inherent strength already and a good solid front edge would be my preference.

Hooray ! Get the champagne ! 🍾 🥂 🎉 What a job !

What is the pressure of your tractor hydraulics pump? With 200bar two 80mm cylinders would give you 200kN. I wrote it before, for bending round shapes I think slower is better. But then, maybe you are working on a sheet metal rolling machine already :giggle: And you do not want to produce 200...

I think this is not trivial and you cannot look inside the rock what structure is there. And yes, maybe not optimal but not wasted either, you got a chunk off. You will get it done (y)

+1 for the warning stickers ! (y) Get two way hydraulic cylinders and run it from your tractor.

They assemble everything and then it gets a coat of paint. Was the same on my tractor (built around 1990), some parts got no paint, but mainly aluminium, so I'd say this was done intentionally. Was doing some repairs on a friends 2016 Kubota L1. Bare metal brackets bolted onto the frame and...

Just make sure to stop for half a minute after each blade of grass cut, so that your rotary mower can pick up speed again :ROFLMAO:

That is the problem, it will be hard to use it because it is so new and shiny. I tell you what: you put this tractor into a glass cabinet in your living room and you buy a well used one for the work. :ROFLMAO:

I use Lidl 15W-40 Diesel engine oil for the engine and Kubota SUDT hydraulic oil for the HST and Kubota filters for everything (come all together in a service kit at a good price). I could not find any of the oils mentioned in the operators manual and the Kubota oil was reasonably priced.