Search results

My guess is if 3pt raises higher when draft control lever is moved rearward after 3 pt control lever has been moved fully rearward is that feedback rod is not adjusted per specifications. My understanding concerning draft control lever is draft lever should be set so plow raises/lowers...

Several yrs ago while handling rd bales with a Kubota M4900 with Kubota FEL I added an adjustable hyd flow control valve so boom wouldn't lower so fast with a 4X5.5 rd bale on bale spears. A similar adjustable type flow control valve could be added to bucket circuit.

Evidently you do not utilize the feature of the built in extendable draft link where one can extend & raise ball when attaching implements to 3pt hitch??

Many yrs ago I owned a M4900 that after operating for while would loose power. After performing many diagnostic procedures I consulted with my local Kubota dealer service manager who advised me to check for blockage in passageway in fuel water separator housing. I located after removing fuel...

Congratulations on getting your tractor repaired. Thank you for updating your thread. That may help future viewers with similar hyd problems on their tractor.

Welcome to this forum I suggest to check battery voltage & load test battery. If battery passes test then clean/tighten all four battery cable connections.

Adding refrigerant to an AC system without monitoring high & low pressures is the wrong thing to do. Too much R14A will cause AC system not to cool the same too small amount of refrigerant. Monitoring refrigerant pressures is the only correct method for correcting the AC problem. Is AC...

Amount of electronics that the tractor has will affect if it's salvageable or not. If tractor happens to have common-rail fuel inj then my guess is your neighbors is in for a bad experience. Do you know the model #?

Welcome to this forum I think it's a high probability that your tractors problems are flood related! Have you changed hyd filters lately? Have you checked hyd oil level lately?

That tractor has a synchronized 4 speed with non-synchronized 2 speed(hi-lo) with a synchronized reverser referred to by Kubota as a M8200DT. I once owned a M4900DT with very similar drive train.

Tractors aren't constructed with same materials as many yrs ago. I suggest when parking tractor for extended period of time to block clutch pedal down.

You're welcome

Thanks for updating your thread & explaining outcome.

Start tractor & after engine reaches operating temperature block traction clutch pedal down. Let engine operate a few minutes in this fashion hoping if stuck clutch plate is the problem it comes free.

Appearance of a battery cable connection can look good similar to a good appearing woman but be bad just the same!!

Has tractor been setting idle for any length of time? It's possible clutch plate is stuck to engine flywheel.

Welcome to this forum More than likely trans input shaft seal has failed. Does this tractor have Sync or hyd shuttle? I'll guess tractor will require a split between engine & clutch housings.

I suggest to check/clean/tighten all 4 battery cable connections paying special attention to ground cable to frame connection. I also suggest to load test your tractors battery

Welcome to this forum I suggest to acquire/read a M7040 tech manual. I think radiator on my '11 M7040 can be R&R without disturbing AC system.

Sorry for you net problems more especially on a holiday weekend. Sounds as if Kubota has a net knife malfunction that they need to correct. I put 30,000 bales on a '05 JD 467 rd baler with very minimal net application/cutting problems.