Search results

They are used to lock the front axel into the cover. Two per front wheel. Works kind of like a snap ring locking in a grove on the axel. It is two pieces because it runs in a recess in the bevel gear. Hard to explain but it will be obvious when you get the assembly apart. No need to replace...

Are you sure its not a block of wood. If it is wood it could be to prop the clutch pedal down to keep the clutch from sticking to the flywheel during storage. I am fairly certain the original equipment block was made of wood.

Your first picture shows the drain plug for what Kubota refers to as the front transmission, When I drain my B7500 I do not get much out of this drain plug. Yout second picture shows the drain plug on the bottom of the transmission/diferential case. Most of the fluid will come out of this drain...

Here is my hydraulic conversion of my back blade.

Using Hokie's suggested parts I think you should be ok. It has been many years since I did the work on my backhoe stabilizer cylinders. In the end I disassembled the new cylinders and installed the rods into the tubes of the old cylinders.

I tried to install replacement cylinders on my Woods BH 750 backhoe. The problem that I encountered was the difference in the ports on the replacement cylinder. On the OEM cylinder the port on the rod end points to the rear. On the replacement cylinder I bought the port points up. When I...

Chech your private messages (conversations) -- white envelope in upper right corner.

I have part #6. I would sell both the manual and the bracket. I will need to see if it will fit in a USPS flat rate box. to find shipping cost. The manual does not have a great picture of the mounting. Hope pictures will help.

I do not have any pictures, however I do have an Operators Manual for the mower if you need any information that could provide. I also have most of the parts for the mower and mounting components.

I have one of the fittings like North Idaho Wolfman suggested installed in the upper hose on my B7100. I don't think my tractor is any different than yours.

Look for a fusable link. It is a short piece of wire designed to melt without harm. Works just like a fuse. On Kubota tractor usually located near the starter motor.

Even with the collar removed it can be very difficult to remove the bearing. Clean the shaft as much as possible. Apply penetrating oil. If the two bearings on the front holding the ends of the auger shaft have been removed and the brace down to the gearbox removed also then it will allow the...

I am not understanding what you mean by "disassemble the internal drive mechanism" . A b2650 snowblower is already protected by 3 shear pins, One on the impeller and one on each of the two augers, You should not need to disassemble anything to replace these shearpins. If you are referring to...

He is talking about a front mount snowblower. It uses the mid pto that has the smaller spline. That size shaft would not be available from a farm supply store.

JDM = Japanese Domestic Market

If you can get all the bolts in by hand , not with a wrench.

I have a set of those on a B2781 snowblower. They worked good. The corner braces that you did not install add a lot of strength. If it was me I would try to find a way to install them or make some of your own to fit. It would not be a good thing to bend the side of that nice new blower if you...

I have a PDF copy of the manual for B2781B (very similar just newer version) I can send you. I also have a series of 24 JPG pictures of the pages of manual for the B2733 quick hitch that someone sent to me. Not very convenient but worked for me when I needed a copy. Send me your regular email in...

Does a B2320 gear drive have a two stage clutch? I do not know the answer to this but I would guess it does not have a two stage clutch. When operating certain types of implements such as a rear finish mower, bush hog or snow blower the ability to stop tractor motion without stopping the power...