Search results

Not the 5" that was called for but plenty to get out and play in. I turned on pandora and listened to a mix of Alabama, Ronnie Milsap, Alan Jackson ( you get the picture) and just enjoyed. Forgot all about the crap going on in the world for a while and smiled. It doesn't get any better than...

Glad I haven't taken the blower off yet. 5 inches of white stuff is forecasted for tomorrow.

send me a pm with your email address and I think I can help you out with a WSM.

I plugged the breather vent and had the new filter ready to go on at 50 and 200 hours, There was a little fluid lost but not too bad. Fortunately my upcoming service is at 400 hours and I will be draining it all.

I thought about doing the same but it will be at least another month before I can even think about going out back without leaving ruts in the yard.

I bought a LX2610 cabbed version in the fall of 2021 primarily for snow blowing. But man, have I found all sorts of other uses from mowing paths around our fields with the flail mower, clearing overgrowth with the brush hog, moving stuff with the forks and recently got a grapple, not to mention...

I know the feeling. We don't bounce like we used to. Hopefully you didn't hit your head when you went down.

I believe it will be around 5-6 gallons between the hydraulics and the front axle. Sort of wondering if it could be used for bar oil.

I'm coming up on my 400 hour service and am wondering if there are any uses for the used hydraulic fluid other than just taking it to the recycle center,

My tail lights still blink with the headlights on. I really don't have an issue with it being that way, I figure it is more to catch someone's eye when they see me near the road.

The cab sure is nice when it's 15 deg outside. This was the primary reason for the tractor. All of the other uses are just gravy lol.

On vacation in Fla so I sent my son in law instructions to run the tractor if needed for the 5" or so of snow expected at home tonight. Oh darn!!

Looking at the diagram I think that if using threaded pipe that 4 unions will also be needed. 2 on the small vertical lines and 1 on both of the lower horizontal lines. This will allow it all to be threaded.

From what I've seen on my lx2610 that looks normal. I use Spray Nine degreaser on my loader arms and snowblower to clean it usually when I remove them for the season.

I put their 2.5" spacers on my lx2610 and am very happy with them. The rear wheels are just within the width of the bucket, They sent all of the necessary hardware with the spacers.

Just finished cleaning this last little storm. About 3" of heavy snow/almost slushy stuff. The blower did real well and the rear blade did good too. I really like this combination.

Sorry for the continuation. Fat fingered submit. The only problem was after the first 10 minutes the snowblower did not want to raise. I believe I didn't have the couplers on tight. Once I disconnected and reconnected it raised very slowly and then went back to normal. Possibly got some air in...

First snowblowing of the season today. We got around 6 inches of heavy wet snow. The blower handled it well. The only problem was a

It's just about big enough. I can fit both of my vehicles and two of my daughter's in the barn along with the tractor during snow storms.

I joined the ranks of those ready for snow.