Search results

It doesn’t show the L35 on that clutch kit just wanted to double check and make sure that’s the correct one. Thanks. Also is it ironic because it could have been fixed with out splitting the tractor? - genuine question as my knowledge is limited. I will post a picture when I get home. Thanks again

Ok thanks

is this something I should leave and not mess with? Thanks

ok sounds good do you have a recommended place as to where you normally buy the parts. As should everything come from a dealer like messicks. I popped off the head cover last night and theres something broken under the rocker arm where the spring is. I’ll get pictures here soon and post.

Ok thanks. Here’s pictures let me know what you think, should I replace since I’m in here anyway if it looks ok? Ok pulled the clutch of here’s pictures let me know what you think. I assume I should replace it since I’m I here anyway? Should I get a clutch center tool when I reinstall? Also...

So finally got around to pulling the engine. Just looking for some direction on the next step. I was following the checking disassembling and servicing in the work shop manual. Should I continue with that. I just finished the 1-s14 page. I’ll include photos of that and the next page. Thanks

Yea I think I’m following you. The lower part has like a small cup on top of the spline that I filled with on plaster and I was tapping it up with a small hammer and a big wrench sitting around the u joint but it started to raise the part up where the roll pin connection goes through the floor...

Thank you for the response yea I had on blaster and been tapping it but won’t budge. The roll pin is kinda facing a direction that I couldn’t get the pin out very well. I’m going to try and do that tomorrow.

https://www.orangetractortalks.com/forums/threads/l35-kubota-shuttle-shaft-removal.73867/ I am finally getting around to taking this thing apart. I posted a new thread with a question im having trouble with removing the shuttle shaft maybe I should of posted it here wasn't sure. Let me know...

I’m dismantling this tractor to split and find an issue with engine or clutch. The step under panel frame says remove shuttle shaft lever support then pull shuttle lever shaft apart. Looks to me likes it’s supposed to come apart underneath the knuckle joint but I can’t get it apart and help is...

what did yo end up doing.

I’m the workshop manual it mentions disassembling the main frame. It’s referring to just the brace and loader main frame? I was looking for some YouTube videos on this procedure but couldn’t find any. Looks like a lot of work - I guess the most daunting part to me is splitting the tractor to get...

Ok thanks for that info I will keep those things in mind. I will update and probably ask some more questions thanks.

would it turn either direction or does it need to turn in a specific direction? The oil was slightly low but not very low the engine was not smoking, I was pushing/picking up a pile of dirt I had dug a tree stump out and was trying to fill the hole back in.

yea my brother in law is saying need to pull the motor and see what's going on. Any good videos or guides on pulling the motor. I guess the maintenance manual would have some info. thanks

With the clutch disengaged punched in and on the hook and the pto lever pulled out when looking from the back turns clock wise with resistance but still easily by hand and free with no resistance clock wise with a slight clicking or ratcheting sound like once per revolution.

I’m not sure how to post a video it seems to only allow photos?

I replaced the starter but same result

I pushed the clutch in and attached the hook same result when trying to start it. What is baring how would I do that. thanks I can tell exactly seems like the noise is coming from the motor.