Search results

I brlieve that tractor has position control so there is no "neutral" position for the 3pt lever. The lever sets the height you want for the "small arms". There is a feedback linkage attached to the "small arms" that will automagically move the 3pt spool to raise, neutral, or lower as needed to...

Why would you be "loathe" to correct oil level? If its overfull - correct it. Worry about any damage if and when you actually experience it. Dan

Leaks from the spool seals can be caused by excessive pressure on the tank port. Do you have any addon hydraulic valves on the tractor? Is the 3pt control lever locked in the full down position when the backhoe is connected? I would not guess at oring or backup washer sizes. Dan

I think the solution is widen the implements. Dan

Thats the nature of your tractor and your "narrow" implements. Dan

The ball joints are there for a reason. Dan

Worlshop Manual is your friend. Dan

I dont know that particular sprayer but: Is the tank fluid circulating? Have you tried adjusting the pressure relief valve? Dan

Backhoe stylw plumbing. It dies not have to be factory of pretty. Dan

Milling machine, laser cutter, welder, press brake.... Dan

Its a 3pt hoe but made for smaller B series machines. Ypu can mount it but probanly going to need a little fine tuning. See this thread for some thoughts; https://www.orangetractortalks.com/forums/threads/l2350dt-retrofitting-a-bl4690b-backhoe.74074/ Dan

My thought is ots getting worse. What have you done in the way of diagnostics since your previous post? Check suction side of pump plumbing for clogged filter and/or vacium leaks. If you have good oil supply to pump check pump outlet side oil presdure both cold and hot. Dan

There you go. Are you sure it will clear the drawbar and top link bracket? Dan

You need to measure but I think you would need a PTO shaft extension and some means to support the pump. Dan

Heres a picture of the PTO on a L2350. Looks pretty cramped in there. Dan

As long as you can fit it on the PTO its fine. But they are big and Kubota likes to obstruct that area with things like gaurds, drawbars, and sway brackets.... Measure twice, buy once. Dsn

It just needs a torque arm which can be as simple as a chain but its not always easy to slide a standard PTO pump onto the PTO of a compact tractor. Dan

Viable if you dont mond the slowdown in speed. Power is a function of pressure so you would calculate it the same way I calculated speed. Do you know what the relief pressure setting is in the backhoe valve? Dan

Your tractor is rated at 4.4 GPM so it will run at 4.4/5.8 = 75% as fast. Dan

I woukd expect most of those are input signals. Some engine sensors (e.g. CPS) toggle the line high (+) or low (-) to signal an event to the ECU. Others like the coolant temp sensor vary the voltage to indicate a value like the temperature of the coolant. The details of that should be...