Search results

When I bought the tractor the cold start rod was missing. When I adjusted the valves the cold start assembly for both cylinder were brazed together on the underside of the valve cover. The springs for the two are ok If anyone has a couple of photo's of the rod from behind the steering wheel to...

The 15261-14520 gasket was too short could not stretch it far enough reused the old gasket with add silicone sealant.

pretty darn close to it. The only difference I can see is the breather bolts to the box. Got a good shot of the prev owners muffler repair Not that I blame him that thing is expensive. Will leave you know ordered b4200 4wd 15261-14520 gasket 15521-05670 breather filter

Tried google and epay but no luck finding a gasket Would like to adjust the valves. A previous owner for some reason removed the rod for the compression release. If I get the cover off I will see if the rest of the release can be removed. That is something someone will use to burn a valve...

I think I figured it out. the little arm with the two stops on it. They have it bent to go by the upper lift arm angle. the lower stop was not leaving the mower down to where the wheels were on the ground. Then after running it would sink down to the wheels. I just adjusted it to leave the...

It may be an adjustment as it only does it when first started. After it is running the up and down work as intended. Or did I get a piece of dirt in the valve?? Last evening I lowered the mower; The wheels did not go all the way down to the ground. Shut the engine off and still no hitting...

Seems like we are into a novel here. This time mowing and heard a strange sound. Looked over the right side of the tractor and hydraulic fluid was spraying from the lower line. When I put the seal in the hyd pump; I noticed the line was welded at the banjo fitting. Apparently between...

I have a universal joint on the way will leave you know The front universal joint took a scenic tour to get here. Apparently the usps put it on the wrong truck; from the start of a tour throw Washington DC and MD. Tried the splines on the pinion. not s real snug fit but it is the same...

I think this is what it may need but it is for a b7100. 67121-57250 Front joint assembly. It does come in pieces but all totaled and the time put together? will that fit the b7000 ? Right now all I can say is it is 14 spline

pinion shaft splines are fine If i use the long half of the universal joint ( the one that splines to the drive shaft) the splines on it slide on the pinion shaft. The short part of the universal joint that should go onto the pinion shaft splines with the hole for the spiral pin locking it...

Boy I think I found the winner of the week. Oil dilution solved. I posted what cured that under the b7000 post. Now after spinning rear wheels find while cutting grass the front wheel drive for the 4x4 is not working. Crawled under the tractor surprise there are no inspection covers...

Pulled the lift pump. Hydraulic fluid from the pump getting into the housing for the injector pump and the lift pump. Ordered a new seal and it seems to be holding. Tried the lift pump actuator while the tractor was running and the only thing comming out of the lift rod was oil ; no leaks...

I am going to run the tractor with the lift pump out when I can find a dry day. Hopefully I will be able to see if the hyd pump is the one doing the dilution. Joe

I was wrong about the hydraulic oil being on the full mark After sitting for a day the oil on the trans dipstick is down about 6mm How do i find out the model number of the hydraulic pump? Even to find seals for the pump thank you

I Found a B7000 with a Woods RM 400 Mower. Mower is in good shape blade fine. Bearings tight oil in the gear box. Lubed and put on a new belt; wish I were 50 # heavier. Bad part after making three passes in the yard it sounded strange. Back to the shed. Checked the oil level and low and...