Search results

i pushed the number 2and 3 piston out had my mentor over to measure the piston bore on all 3 he said that the wear is minimal . i was glad for that until i grabbed the pto shaft in front to see the crankshaft turn and could feel something slow down the turning i mentioned to my partner this...

i have new piston a new intake valve 3 sets of rings and rod bearings on the way from messicks . the two dealerships i talked to were way out there for prices and advice. at least this blog has people you trust for the problem on hand and not trying to make a buck on my lack of diesel tractors...

i just pulled head off the b6200d and found a washer in the number one cylinder . pulled all 3 pistons and the front cylinder had a hair line crack . off to the head sop and getting valve seats cleaned up ordered one piston 3 sets of rings rod bearings valve that was twikked by the washer...

well the chunck noise i hear when turning engine was not hydrolock . it was a washer must have been in air intake pipe and got sucked into the cylinder head then going to the front piston . the intake is bent and will need to be replaced . taking the head to a machine shop to see if it ok to...

my b6200d has the same issue i try to turn the engine and get a chunk and that is it . my tractor did not have a rollover but i did have the injectors repaired the original owner let the tractor sit and rust was in the tank filter was like a deformed worm etc. i did not know about the purgeing...

So I am waiting for new solenoid as the shop I took it to said it is defective. Now I am looking on the side compartment where the governor is and I can see the control rack is locked up . I need to get it free so I will be able to purge the fuel and then shut it down after a test run.

ok so i am currently in a stupper with my b6200 . I did a bench test with the starter and solenoid and I hooked up with battery cables the positive lead that is on top of solenoid grounded the negative to the outside of the starter. I then touched the connecter that goes to ignition to the...

Thanks for advice I will posting my issue with the tractor in a couple days.

Thanks oldhokie I am going to take the radiator today and get it cleaned and tested for leaks . I will be painting the front end of the B6200 since I went a step further with my tractor. I will report back when I start to engine. Being retired just means you do work you enjoy and getting the...

I had all 3 rebuilt new nozzles and pressure tested. I have opened the relief valve above fuel pump also put a new fuel filter and cleaned up rusty tank. I have noticed the kill knob will not allow me to be pull out so I can turn engine over so the fuel pump will get fuel to the injectors. All...