Search results

No Sir, temp seems to be running a bit high but its been real hot here in Texas. reservoir says its at recommended level.

My BX 2660 has started blowing whitish exhaust smoke and running rough intermittently....installed new air filter, drained and replaced all old fuel and did all the trouble shooting procedures recommended. Ran fine for a while then started doing it again... any suggestions :confused:

http://www.orangetractortalks.com/forums/attachment.php?attachmentid=19014&shttp://www.orangetractortalks.com/forums/attachment.php?attachmentid=19015http://www.orangetractortalks.com/forums/attachment.php?attachmentid=19016&stc=1&d=1447860523&stc=1&d=1447860523tc=1&d=1447860523 these are blade...

I would put some pics here to further explain the problem if I knew how

Just put new blades on my BX2600 with 60 inch mid-mount mower. I have mowed twice and both times the yard looks "striped" and the mower seems to be leaving the grass uneven by just a hair. Besides the blades being dull, the mower performed as it should before the blade change. I didn't install...

Ok, so I tried all suggestions and got close but no cigar ... Noticed that the left arm was making a nasty noise when retracting/extending and I figure I got a bad or damaged cylinder. Any thoughts ?

I have driven up to it, hooked up the hydraulics and raised and lowered the arms repeatedly.they will both retract entirely, but when I try to raise them so that I can reattach it, they go at different speeds and two different levels… That is to say they are not raising together equally...

Seriously ...? Hints on how to do that ?

I have a 2011 BX2660 with a loader that is giving me fits. I took it off a few months ago and when I tried to re-attach it, the arms do not move in tandem or equally so it wont line up properly to fit. Hydraulics problem... ? Any Ideas how to solve this would be greatly appreciated.