Search results

Welcome to the group. I replaced a deck on my trailer also that was held in a channel at both ends, but I found the channel at the back was actually a piece of angle iron that was put on after the new deck was layed down and tack welded all along the length, all I did was zip cut the tack welds...

Thanks for the info. so I think then I need the T port one

Check out the cab I build in Fabrication section takes a lot of hours but is worth it, not a fan of aftermarket cabs to expensive

The # was 424003 but I can't find it now and I just bought it in Sept it was a 13,500 BTU unit, maybe its been replaced already 2yr warranty

Thats what I was thinking also

I ran my heater hoses from the small 3/8" hose at the thermostat. The hoses change from 3/8's to 5/8's on heater there is no restriction according to heat I'm getting

I have installed my princess auto cab heater and it works great--to great, I'm down to my t-shirt. I was thinking of putting in a 3 way valve on one of the lines to the heater therefore I could restrict some flow and return that anti-freeze back to the rad. Has anyone tried this.??? I did try...

Sorry haven't been on the site for awhile I'll get the pt #, but it is a 12 volt 8inch stroke cylinder thks

Got my 12 volt cylinder Princess Auto) hooked up on snow blower, also put a small box with switch inside, closer to chute rotation lever. THks

Hello I bought my B2601 in June this year. When we asked about insurance, my insurance broker asked how many HP. According to the Canadian B2601 brochure it is listed at 24.3, the insurance said that it will be covered under my homeowners policy, all I had to do was raise my coverage to cover...

When I got mine didn't notice till I was underneath looking around and seen the orange was terrible, looked like one light coat over primer dealer said do you want a can of spray paint!!!!!!!!!!!!

Hello all, just wondering who would have any advise on buying a 12volt cylinder for a snowblower deflector hood and what is a good one to buy. Not sure about amazon ones Thks

Hello all just showing another mod I made to my B2601. Never liked the steps Kubota makes for stepping up onto the seat, they are flimsy and seem to deflect the sheet metal on the floor board and fender, very poor design. So I made mine from 2" tube one length from one side to the other, all I...

Hello everyone, I have hooked up my cab heater on my B2601, from the info. in this forum I used the small bypass hose at the thermostat. I ran my lines through the heater and back. My question is, first off it works good the heater is quite warm, but my question is I'm thinking that the heater...

Yup going to put one on but I'm trying to figure out how I can add a grapple top arm going to come up with a plan--winter project.

Thankyou, I think I will in the near future put wheel spacers on, but very expense here in Ontario

I just finished my fort lift attachment for my B2601 (not painted yet). Got some dead ash logs and was so glad I had this attachment done, they where so easy to lift off trailer, this will be a great piece to use. I made the quick attachment from old steel I had, then bought a 36" pair of...

Hi, No I wasn't, first Can't get in my shop when its up, can't see when snow blowing that good, and I'm on level ground so pretty safe and I think with the way I built the cab its just as safe or safer thks

Yep got a heater in not hooked up yet and adding strobe light work lights

No that was not me