Search results

I have an m9540 Kubota cab tractor. I bailed hay for 4 hours Tuesday 6/7/23. Went to crank this morning (6/8/23) and it ran a little ruff for 30 seconds to a minute and quit. Before starting in the hay I changed all filters and cleaned the water separator. It looked clean but I wanted to make...

Must be having a short circuit in my brain. Could not find where to start a new post. I’m in need of help with my M9540 Kubota. I bailed hay for about 4 hours yesterday. Went to hook to my mower and when I cranked it it ran for 30 seconds to a minutes and it shut down. Was running a little rough...

I have an M9540 Kubota. My brake, turn and hazard lights are not working. Fuses are all good. I can’t locate the brake light switch. Any suggestions would be greatly appreciated. rl

If anyone has had experience with the master cylinders on these tractors I would appreciate your input on how to tell if the master cylinder is bad. The right pedal will pump a couple of times and have a little pedal so I can get it to stop if I have enough time to pump. In my experience with...

How do youif the master cylinder is bad? With automobile brakes you can keep a light pressure on the pedal and it will creep down if the fluid is leaking back past the master cylinder washers. Done mechanic work on many things in my life but this set up is a new beat for me.

I have an m9540. I took the radiator and hydraulic cooler off to have them pressure checked. Now my brakes are almost non existent. I have to pump the right pedal three times to get a little pedal to slow it down and the left will not even pump up at all. I tried bleeding the air out and got...

I went through the process of checking all of the fuses to ensure I had juice on both sides. With that confirmed and some information from the net I pulled the floor board and found the three junction blocks located there. i took them apart and found a little corrosion. Cleaned it up and put...

Sorry about the double post but I didn’t see where it was posted. My phone and service has been terrible for 3 or 4 days now.

Thanks for the info. I have checked the slow blow fuses and all are intact but still no power to any of the wires going to the switch. The tractor was running when I parked it to replace the cooling components. Now there is no power to the switch. Could a relay go bad just sitting?

Thanks for the info. I have checked the slow blow fuses and all are intact but still no power to any of the wires going to the switch. The tractor was running when I parked it to replace the cooling components. Now there is no power to the switch. Could a relay go bad just sitting.

Thanks for the info. I have checked the slow blow fuses and all are intact but still no power to any of the wires going to the switch. The tractor was running when I parked it to replace the cooling components. Now there is no power to the switch. Could a relay go bad just sitting and could that...

Do you have or know where to access the same information for an M9540 cab tractor. Or is the wiring and fuses etc. the same? Thanks

I have an m9540 cab tractor with shuttle shift. Can’t find information on what letters come after the m9540. Thanks

I replaced the radiator, water pump, fan and thermostat on my m9540 Kubota. The tractor sat for over a month while waiting on parts and doing the work. When I got everything installed I was ready to crank the tractor, service and get to work. The tractor would not start. The battery is charged...

Thanks for the advice. Found the drain plug to the left of the oil filter. With the loader, hoses and can I could not see it until I had a specific target area.

I’m changing the radiator, water pump, thermostat and engine coolant. I cannot find where to drain the block on my m9540 Kubota cab tractor. Appreciate any guidance.