Search results

Ok, sounds good. Is it a reasonably good quality piece of equipment?

Hey guys, just want to run this by you. I'm thinking of ordering a set of Titan pallet forks: 48" , 4000lb. capacity, 6-46" width adjust. I talked to the rep on the phone and he couldn't assure me that they were compatible with my Kubota LA1154 quick detach loader. So I thought I'd run it by...

Thanks, will ask the dealer about that, too.

I hope to get by the dealer sometime next week while on vacation to see what I can find out. May just be the nature of the beast.

I agree, my Kubota lifts the implements up ok, just not near as high as the Ford. I do have them in the lowest hole already where the top link connects. I've also experienced the same thing with the pto shield, just makes it harder to work on attaching/detaching pto driven implements...

Not sure about holes on the lift arms, will have to check that out. Thanks.

Sorry, won't see the tractor again till Saturday. Do you think it would be out of adjustment from the factory? Maybe I should run by the dealer and have them show me how high one of theirs goes to compare to.

Hello all, I recently purchased an M5660 and it seems to me the tpl doesn't raise as high as it should. I have a 63 ford 4000 and it seems to raise almost twice as high as the Kubota. I don't know if this is normal for the Kubota or not. I already have the top link attachment in the lowest...

Ok, thanks for the info. Better take it off and try again.

Well, I emptied the water separator and successfully bled the system today. But after I was done I looked at the separator and the red ring was at the level where it says it needs to be emptied still. When I took the cover off the separator there was a spring laying in there. Hard to tell...

Won't emptying the water separator be sufficient? Repeatedly, if necessary?

Thanks, for the nice pic. Hopefully mine will look similar to this.

Ok thanks, will check there. Won't see tractor till next Sunday though. On a related note: how often do you have to drain the water from the separator? My tractor only has 8 hrs on it and the separator looks to be full already. Is that typical?

Hey guys, I have an M5660 and I would like to bleed the fuel system. According to the manual you have to loosen the air vent plug on the fuel filter. I'm having trouble locating this. Could anyone tell me exactly where this is? In relation to the water separator, where would it be located?

Thanks for the advice. Will using the bottom hole of the top link mount be ok with a 6' Landpride bushhog? Not sure what it weighs.

I recently took posession of a new 5660 with a brush hog attached. It doesn' t seem to lift very high, at least compared to my old '63 Ford4000. I'm not sure if that's all it lifts or is there someway to make it go a little higher by altering the hookup points, etc. I know I could shorten the...