Search results

  1. V

    Help on clutch install on a L3130

    I appreciated your advice the rear wheels do spin the shaft, very slowly. I got it together but disappointed to find I lost the throw out after testing for about 10 minutes of every thing working. I fear I did not tighten the throw out shaft planning to torque it. I abandoned the torque wrench...
  2. V

    Help on clutch install on a L3130

  3. V

    Help on clutch install on a L3130

    I separated it this morning just a matter of raising the dash and securing it again. I am fabricating a 2 spline alignment tool to replicate the transmission. I will post pics when done of the splitting rack I made. I tried all my old tricks but was not sure if the GTS transmission shaft would...
  4. V

    Help on clutch install on a L3130

    After waiting 2 months for a tractor mechanic I took on the clutch replacement on myself. I built a splitting rack and set up numerous jacks. My issue is getting it back together. I am all lined up with an inch or so to go. The alignment tool had one spline for the disk. . I pressed a socket on...
  5. V

    back hoe swing piston repair solution

    I will get some pics, Unfortunately I lost the clutch right after finally getting the back hoe right after 5 yrs. Bill
  6. V

    back hoe swing piston repair solution

  7. V

    back hoe swing piston repair solution

    I was not sure any one else had run into this, I fabricated end caps to go over the originals with seals. I used 1X4 inch steel bar. The same thickness as the end caps on it. I was then able to reproduce the slots that the chain connects to. I can post pictures if some has this issue. I...
  8. V

    back hoe swing piston repair solution

  9. V

    back hoe swing piston repair solution

    If any of you have ever had the chain connection/s on you swing piston I came up with a permanent solution after years of jury rigging. It wasn't $1200 dollars for a new one. Bill
  10. V

    Kubota Grand L GST will not move.

    Thank you for the input, The PTO works. I used a stethoscope last night and confirmed the F/R was connected. The clutch does appear to be be operating as well as the hydraulic clutch. I forgot about the intella panel. No error codes. Bypassed the GTS no response in emergency mode. At this point...
  11. V

    Kubota Grand L GST will not move.

  12. V

    Kubota Grand L GST will not move.

    I have had my 2003 Kubota from new. I did have a new clutch put in about 10 yrs ago because I thought it did not have a dry clutch and let the free play let out even though I constantly checked it on my 66 427 vette. I learned a lesson. This time no smell, good free play every thing was fine...
Top Bottom