Search results

Never done one on a tractor. If its anything like the old automotive steering boxes. Remove the pitman arm, any related washers or snap rings. With box still in tractor, start tractor and turn steering wheel, pressure will push out both seals. Might make a slight mess. Not sure this would work...

Bump

Bump - still looking

Bump, still looking, thanks

What happened before this, little history please

Thank you all for your input.

Glad your mystery is resolve

Just acquired a new to me, B2920, My old HF quick hitch went with my BX22. Are all quick hitches created equal ? Give me your thoughts please.

Ground circuits fail under load. They can test fine with a volt meter while not under load. Wiggle the wires at your ignition switch while attempting to crank over engine. If the harness at the switch was all you touched when you replaced the switch, sounds like you might have a broken or bad...

Phasing the u joints just means, aligning the open part of each yoke, front and rear on the same plane, at that point the closed part of yoke will also be on the same plane. Does that make sense ?

Thanks, looking for a snowblower now.

The BX22 sold in 4 hours about 6 weeks ago, was testing the water (silly me). While awaiting the arrival of LX2610's to the dealers i found a B2920 with 180 hours, a backhoe, chipper, mmm and rear blade. Not as large as the LX, but in great condition with nice array of implements. All in all...

No longer looking, Found what I needed.

Unit Has been sold

check your connections including grounds