Search results

@TheOldHokie my wrench is pointing to where removed. This image shows how the release handle runs into the loader and doesn't allow fitting to release (handle is as far forward as it will go here). Maybe the handle itself is bent? Pretty heavy steel, not sure.

OK so I finally had a chance to check this out. I asked about simply unscrewing the hydraulic hose from the rod end at the fitting because in doing so, it leaves the other end (where the hose attaches to the swift tach fitting) open-ended. I was thinking it being open would suck air in when I...

Hi, didn’t have a chance today between work and kids sports but was thinking about how to do what you said - tractor does have swift tach loader. I’m not 100% sure how to remove rod end/individual hose with this type of connector. Is it as simple as unscrewing individual hose with a wrench?

Yes, I believe so too as he said he took off those lines and flushed etc. But maybe as @TheOldHokie said something is wrong with the coupler? I plan to try swapping them when I have a minute. What about swapping the lines so curl/dump controls lift/down?

Hi Dan, yes, the backhoe works well.

Thank you for your replies. To answer a few questions, the tractor has low hours, around 100. The hydraulic fluid has been changed and shows a bit high on the dipstick. There is no third function and engine speed does not affect performance. The control stick for loader seems fine, except when...

Hello, I have a new to me B2301 which has some hydraulic issues. The FEL does not lift as supposed to. Pulling back on the loader control, it will raise the bucket slightly - initially only a few feet off the ground (sometimes not really at all). But, pulsing the control lever back slightly...

Maybe not all that unlikely…I just purchased a used B2301 and I found this thread as I have what I think is the exact same problem. The B2301 has had a backhoe on its whole life and only has around 100 hours. The 3PH lever does nothing (should raise the mower deck). You say if you can move the...

The tractor is 4x4.

Hello, I have a tire sizing question. I picked up a B6200 which has the stock size tire on the front (20.5x8.00-10) however the rears that came on the tractor (which should be 29x12.00-15 according to TractorData.com) are 31x15.5x15. I'm looking to replace the tires and found some new...

Sent email, I'm interested in the lower grill if same as B6200