Search results

I did end up using those parts, yes. Before removing the delivery valve holders I would make sure to very thoroughly clean the top surface to make sure no dirt, etc can fall in. I used an air blow off in conjunction with a brass wire brush to knock all of the gunk off. You’ll want to also use...

Just an update...I replaced the o-rings and copper crush washers. The machine ran great, idles much better now as well. Also no more fuel leaks out of the injection pump. Thanks again for the help.

One more thought… If you’re driving forward and then change direction to reverse, any noise then? To me it sounds like something in the hub, axle, or maybe drive sprocket on that wheel. One way to find out would be to jack up that side of the machine if you haven’t already and try pulling the...

Thanks, appreciate the feedback!

Maybe a loose pin / bushing on the right rear lift arm, though I've never heard or seen of that myself. Do you notice any odd sounds when lifting the bucket up / down?

I now understand what you’re referring to after more research. From the linked thread in my first post related to the L4200, the advice seemed to boil down to being careful to not disturb the internal components (i.e. rotate them) in order to preserve the fuel delivered. Is there any other...

If you have a load of dirt in the bucket while going over bumps does it change how much of a clunk there is? Does engagement / disengagement of the ride control have any effect?

Does torquing the delivery valve holders to spec not accomplish this? It’s unclear to me how the holder can set the curve. Reading what little I’ve been able to find suggests that the curve is fixed by design (spring rate), again assuming the valve holder is properly torqued.

After looking in the L4200 catalogue on Coleman's, it seems the injection pump assembly part number (16454-51010) is the same pump assembly used in the KX161-2 catalogue. The component parts listed for the L4200 injection pump would be valid for the KX161-2, I believe.

I have a SSV65 as well but do not have specific experience with clunking. A few things that you could look at: Did the right rear wheel come loose from the hub? I would jack the machine up and make sure the lug nuts are snugged down. Are the axle hub nuts tight? These are the nuts that are...

Hi All, I'd recently purchased a KX161-2 excavator with the V2203-BH-5 engine and have noticed fuel leaking from the delivery valves on the injection pump. Reading through this website, it appears that the o-ring and/or copper gasket is likely the cause. After digging through the parts...

Hi All, I'm looking for the WSM for the SSV65 skid steer. Is the dealer the only source for this manual or is there a reputable online source with a PDF version? Thanks!