Search results

So I removed the other side (driver side) last night, and found it to be 25.4mm (1"). I cleaned up the first one and found it to be well worn, out of round in places. I think the other guy only used grease on the outside of his joints lol I'll replace the part and go from there. And I cleaned...

Off to tell the wife i need a $1k lathe for a $25 part....... I"m sure she'll understand.

The grease is from the original owner. The other side is not nearly as bad. He was very sloppy. Maybe i'll pull the other pin though and measure it. If it's bigger, then I'll just go get another pin from the dealer.

Do you think the amount of play is an issue that needs to be repaired? I just bought the tractor used and am going through it with a fine toothed comb. I'm not sure what to expect with regard to this level of play.

That was my thoughts also. I have over 700hr in my BX without play like this. I wonder if the previous owner hit something, as the SSQA plates are also misaligned by about an inch. Video link below - I suspect I"ll have to replace the weld on bushings. Does anyone have a part number for those...

Thanks - looks like your pins bushing have a tolerance of around 0.3mm gap, while mine is around 0.8mm. Thanks for posting the chart. I managed to upload the video: https://www.youtube.com/shorts/tTMPMR0LbHg

Good afternoon, I have a fair bit of slop one of the pins in the loader (LA534) on my tractor (B2650). The is the upper cylinder pin in the below screenshot. I have what seems to me an unusual amount of slop in the joint (tractor has 250 hrs, was not well taken care of before I got it...

This kid was a worker on a job site when this happened - he and another teen were being transported to and from a work area. It's well known that young people are more likely to be hurt/injured and that proper procedures, policies, and yes even stickers and signage all help prevent injuries...

Thanks guys - this is very helpful

Thanks. What do you mean (K or M)?

I guess what I need to know is will the subframe fit (probably not) and if I need to reduce the hydraulic flow so the backhoe works. Anything else? I plan on selling the BX once spring arrives. It would be nice to keep the backhoe but only if I can make it work on the B2650

Good afternoon, 1st post. I have a 2016 BX25 and after owning it for a few years I've determined its a touch small for my needs. I've since bought a 2017 B2650. The B2650 has a set of 2 rear remotes. Is there any way, that I can make the BT601 (backhoe that fits the BX25), fit on my B2650...