Search results

Vic : I measured the tabs, they are within specs, so did somemore looking and seen that the new disc is tight on the new shaft. So I cleaned the groves and the flat ares with a file on both and it is a little freer. No it still didn't worh well. I looked threw the inspection hole I made in the...

Milo The clutch rod is threaded all the way outon the clevis, might have to weld a new longer rod Thanks jerry

Yes the throw out bearings is identicle too the old one. Same part number. thanks jerry keep trying. Cause I don't give up Jerry

I tried to reverse the forks and it won't work. The fork is keyed and the tabs according to the book and the techs the tab curve faces the rear of the tractor. Now you see why I am frusted. I work on a 70 challenger 76 duster,66plymouth satellite, and am restoring a 48 dodge pickup and have...

That's a good thought but I put new linkage in. Also the old clutch even with the broken disc worked good except for it chatering. So something changed when I put a new disc and pressure plate in. Then put new shaft with fle coupler. pilot bushing, springs, throw out bearing, fork and fork...

I come to the conclusion that the pressure plate is out of wac. I cut a 3'x3' square out of the bell housing on the right side making this an inspection hole. I will make a plate for future use. I was able to see that the clutch doesn't release enough to keep the disc from turning. So looks like...

I split the tractor this morning and measured the old disc and plate compressed and uncompressed and it checks out. same as the new clutch. Checked the pilot bushing and it's ok. Measured the shaft with the flexcoupler and without and matched to old one and they are right. Measured the bell...

I had another clutch and disc from A@I that had the disc springs that were not secured to disc and there pressure plate did the same thing not disengaugeing. This new pressure plate and disc is a Kubota part from a kubota dealer. I am lost on what to do. I rebuilt the engine 3 years ago and put...

I already looked at that. This disc can't go in backwards as the hub on the disc will hit the fly wheel bolts. I had it apart again

I have a B7100 3 speed manual transmission. Clutch disc broke. I installed a new pressure plate, disc, pilot bearing, clutch shaft with a new flex coupler, throw out bearing, bearing sleeve, clutch linkage, release fork and linkage, and misc springs. Flywheel was inspected and was ok. I adjusted...