Search results

Thanks for the link. I checked with them and no luck. I will keep looking. Any other used tractor resources out there?

2 problems. The toe rod hole is pretty worn out. The big issue is the previous owner never fixed the lower caps/plugs that hold the oil in. It was then used until it would not longer move. I bought it and braized the cast iron axle housing and replaced a bunch of bearings and seals. The...

Hi, I am looking to find replacement axle cases for the left and right front of my 2850. The case I am looking for is where the tie rod hooks in out by the wheel. It seems these are impossible to find. Any suggestions?

This is what i am trying to hook up to my loader. It has all come from the scrap pile. Mechanically it should be good I just want to figure out the best way to get hydraulics to it.

Hi again maybe I asked too many questions sorry. I assume that when I buy a new spool valve it will new to have power beyond capability? Would it need to be open centered as well?

What I had in mind was an open center control valve. Pull the lever and the cylinder moves, push the lever and it moves the other way. Thanks for telling me how to hook this up! I would like to understand this a little better so if you don't mind I have a few more questions. The out port on...

Ok I am back on this project. I have the grapple built and ready to install. I have plumbing questions, if I want to use a manual valve to actuate a cylinder where do I tap into the hydraulic system? The loader valve I have has 7 lines going to it. The pump feeds the block as shown in the...

Hi i am new to this forum and I was hoping for some insight on adding a grapple to my loader. I would like to use the loader valve to supply power to another valve to actuate a grapple cylinder on the bucket. I am not sure if the factory valve has the power beyond port. The manual talks...