Search results

One of the seals started leaking, so that is why. If I grab the tire at 3 and 9 o'clock i get the slop. If I grab it at 12 and 6 o'clock I can't really tell because the entire front assembly wants to pivot at the center point. Suggestions?

He installed a shim in the front axle of case because of finding the one bent up inside of the front gear case and then installed one where it is marked in blue on the axle flange.

Already downloaded this morning.

Ok, when he removed the axel flange from the front gear case, a shim was found pushed inside of the the hole on the gear case marked in red in my picture. This is confusing because they only show a shim marked in blue in my picture that is to shim the bearings on the axel flange. Did the last...

Saw no visible signs of damage to gears or housing. Any suggestions on determining which if the above it might be?

Don't know where to look at that plus no reason to not post here.

Where is a good place to get a service manual?

He told me the bearings were good. So no, they weren't replaced. The axel it tight in the wheel. When I grab on either side of the tire while facing the wheel if I push with my right hand a pull with my left like I was steering a motorcycle, it will rock back and forth. It's like the axel is...

We had the parts department print the blown up view for him.

It is also 4wd.

It was the safety switch.

I was box scraping our road the other day and one of my frontwheels, spindleand all fell off. I had a mobile mechanic come out and he pulled the wheels assembly apart and found only a part of one of the two clips or keys that goes into the groove in the spindle. One of the thin bearing spacers...

Anyone have any more suggestions? If not, I need to get someone out here so i can spread gravel on our road. Thanks.

This is the switch. In my original post I asked for tips in disconnecting the switch. I can barely get one hand on it, so no, I haven't been able to disconnect and test. I have no idea if those two bolts could cause this to happen. I really don't see how that could occur, but who knows.

Ok, here are my findings this morning. I pulled the switch on its mounting and worked the switch and it never flashed dim or bright. I moved the treadle as well while the switch was out and nothing happened. As soon as I put the switch back in the mounting and rocked the treadle back it came...

Ok, what I found is with key on the light doesn't come on with any lever or the brake pedal. It will flash every onec in a while when pushing treadle in reverse and occasionally it's like the pedal doesn't want to fully return to neutral. The light comes on bright and stays on until I manually...

Thank you very much for the information! Will be trying that later today and report back.

May be wrong but I have read about more than a few similar situations and the speed control safety switch was the issue. I am not very mechanically inclined but can follow directions. I have never used a voltmeter but with some direction I should be able to test with one. Reverse switch, no clue.

My fuse keeps blowing. Boy is this frustrating when you need to use it and this keeps happening. I shot some wd40 in the boot and worked the plunger back and forth. It ran for 30 minutes and when I went to back it up to park it the fuse blew.

I have been having problems with the 5amp fuse for the panel blowing when I go into reverse. I tried to remove the safety switch yesterday but was not able to get my hands on the connector to disconnect from the tractor. Can anyone give me some tips on how to get this apart? I was going to...