Search results

Rake or shovel , stick the handle in it. They drain out the bottom

No - brush painted (krylon) It didn't fill in all the pours, but most. You have to be looking to buy to see the white dots :)

Completed Project

I welded up that frame out of scrap iron I had laying around and painted it black. Paint covers up my crappy welding :)

Finished my ballast box for my B3200 36x16x12 - about 500# Next week I will remove the forms and paint

could you write down the part numbers so I can update my dealer?

We looked in the tractor, loader and backhoe parts books.

I have a 2011 B3200 w/LA504 loader Underneath on both the right and left side is a gray bar that bolts to the front end loader, the frame and the rear axle. It connects tot he frame with 2 bolts on each side. I found these bolts had come loose and fallen out, most likely never tightened. I went...

I found a good price on a light weight wet of pallet forks for my B3200 http://www.skidsteerexpress.com/cgi-bin/shopper.cgi?preadd=action&key=FORK3FORK I was wondering if anybody had used these and have some comments, pros/cons? 2300 lb capacity (I think the safety ratio on forks is 3:1) 36 “...

Actually that is an F250, you are correct with 1959. That is the first year Ford put 4 wheel drive in at the factory. Prior to that it was a dealer add on. My wifes late father bought this truck new, it has never left the family. All original and runs like a swiss watch!

Fabricated a bolt on tooth bar, cost me about $100 total Tried it out and it worked great Now I definitely need a ballast box - next project

Here is a photo of the shank and tooth I found I will post a picture of the completed bolt in tooth bar when done. I welded it up today and painted it this evening, should be ready to bolt in tomorrow

I found the shanks I needed locally CNH Part # 7703993 Now I can start this project this weekend

I found this older post http://www.orangetractortalks.com/forums/showthread.php?t=2087&highlight=tooth Which lead me to this vendor in Bonner Spring, KS http://www.colemanequip.com/parts/CaseParts/B504447 It's a start!

I have been looking for weld on teeth to weld to a bolt on tooth bar. Our local implement dealers don't have the kind that are long enough or have the right bend to make a good attachment. Does anybody have a on line source for weld on teeth? I don't need heavy duty, this is for a B3200. How...

A rear scraper or any rear implement is fine for ballast but now you have to watch out for one more thing when backing and turning. A compact ballast box with tool holding features is the way to go. I want to keep my cg as low as possible so I was thinking about adding pipe legs to the 4...

Not completely. If I release the lever from the full up position it will rebound to lower If I release the lever from the slow up position it will return to neutral (most of the time) If I place it in the neutral - it stays there and does not creep down. I have gotten into the habit of manually...

Operator Error!! I talked with my dealer and he showed me how to correct it. That round knob below the front side of the seat for 3-pt speed control. When this is set too close to the "Open" position this will happen. I though it was for how fast the 3-pt comes down but it also effects the...

If you were building a custom ballast box for a B3200 (500#) how far from the bottom would you center up and place your bottom arm pins?

I have a new 2011 B3200 and am questioning whether my 3-pt control lever is working properly When I raise the 3-pt to the top and let the lever go it recoils to the slow down position - is that normal? I think it moves to the down position with the slightest jar. I would be picking up some dirt...