Kubota B7001 - hidraulicos

[Antonio Chora]

olá
o meu kubota b7001 não tem ligação hidráulica traseira, e pretendo adaptar o terceiro ponto hidráulico
já alguém fez essa adaptação?
existe algum esquema prático, ou imagens dessa alteração
obrigado



Moderator Translation:

Hello, my Kubota B7001 doesn't have rear hydraulic linkage, and I intend to adapt a third hydraulic point. Has anyone done this adaptation? Is there a practical diagram or images of this modification? Thank you.

 

[Russell King]

I think you are trying to add rear remote hydraulics to your tractor.

See this thread starting at post #1 to see a block to replace on the tractor to tap into the tractor’s hydraulic system. Then add as many rear remote valves as needed. The valve must have High Pressure Carry Over (also called Power Beyond) outlet and that is routed back to the block.

B7100 Hydraulic block diverter (70060-00360 or 70070-00385)

Back in stock. CDN$40 plus actual shipping These are obsolete and no longer available. I have recently been contacted by a member asking if I will make him one of these after reading how I made mine. I know this comes up from time to time and would like to gauge the interest others might have...

www.orangetractortalks.com

See post #16 in this thread for an example of how that block is used on a Kubota L185 to power the rear remote valve for top and tilt.

Rear remote hydraulic on Kubota L245DT

My L245DT has aftermarket power steering..does not have a front end loader. The power steering cylinder is connected to the control valve below the left side of the seat via an aluminum block. How do I do this? Thanks for any help.

www.orangetractortalks.com