Long bushing for Cat 2 lift arms to mount Cat 1 implements?

[trackman23]

I seem to have quite a bit of space on either side of my lift arm when i mount all of my implements and as a result, the standard 1.75" long bushings dont have much area to bear on. Any idea where I can get some longer ones? Online searches at tractor supply and agri supply don't seem to show any options.

Thanks,

 

[SDT]

I use multiples.

Sometimes cut to fit.

 

[GreensvilleJay]

hmm
support bushings only have to be as wide as the lift arm 'ball' contact width
push lift arm in , to where pin meets implement,
then fill outside 'gap' with washers( spacers) to where lunch pin fits

 

[Heehaw]

I had the same issue with my BushHog and did as SDT said about using multiple and cutting one down. It took a little over 2.5 bushings on each side.

 

[animals45]

Is this with all attachments ? Are the lift arms adjusted properly ?
animals45

 

[trackman23]

This is a typical situation…not much bearing surface on that bushing. I like the multiple bushing idea.

 

[jyoutz]

I use multiples.

Sometimes cut to fit.

I use two bushings on each pin on my rotary cutter.

 

[mikester]

https://www.princessauto.com/en/searchresults?Nr=product.active%3A1&Ntt=cat1%20bushing*&Nty=1&No=0&Nrpp=50&Rdm=309&searchType=simple&type=search

 

[Foreverworkin]

I seem to have quite a bit of space on either side of my lift arm when i mount all of my implements and as a result, the standard 1.75" long bushings dont have much area to bear on. Any idea where I can get some longer ones? Online searches at tractor supply and agri supply don't seem to show any options.

Thanks,

LandPride part number 326-236D. 1-1/8" OD x 7/8" ID x 3-3/8" Long