Recent content by Timbo10835

Can anyone tell me where to order the lift cylinder seals or have part numbers? Thanks in advance.

Can anyone tell me where to locate it? I'd like to shim it to gain 200 psi for the FEL.

Back up and running...turns out the new, OEM injector I installed was defective. It was spraying way too much fuel that caused the engine knock and smoke like all hail. Replaced it with another new injector...now runs great ! Even better actually since I ran some Seafoam through the fuel...

The original injector went bad wasn't delivering fuel. Replaced with a new oem part. I've bled all three at the injector. When loosened, #2 and#3 don't effect the knock. Only # 1 does. I am bleeding with the engine running,should I only when cranking it over but not running? I had a fuel...

Looking for advice. I replaced cylinder 1 fuel injector then bled the fuel system at the injector pump (knob) and at each injector. Now I have what sounds like intermittent fuel knock. If I loosen the injector at #1 like bleeding,knock goes away. Any ideas? I bled it 4-5 times already.