TheOldHokie's latest activity
-
Using a suction gun only removes part of the oil. Any water will remain at the bottom of the gearbox around and below the lower... -
TheOldHokie replied to the thread L4400 fel not working.I see no point. He is getting full flow through the coupler. None oc this adds up. Disconnect the red hose at port C, stick it in the...
-
TheOldHokie replied to the thread L3902 HST - 3 point lift needs a small increase.3000 PSI liquid filled gauge 1/4 female NPT x JIC-06 male adapter 3/8 x 24 R16 hose with JIC-06 and JIC-08 female swivel ends JIC-08 x...
-
TheOldHokie replied to the thread L4400 fel not working.Based on your description that hose goes from the PB port on the loader valve to the rear coupler and loops back to the C port on the...
-
Where do you have your draft control lever set and you are moving the position control lever all the way towards the rear correct? If it...
-
TheOldHokie replied to the thread L4400 fel not working.ARRG! I thought we eliminated this possibility early on but apparently not. That is a power beyond loop for something like a backhoe...
-
TheOldHokie replied to the thread Milky oil in gearbox..Do it again and this time flush with something like Gunk SC degreaser mixed with diesel. That will pick up residusl water. Might want to...
-
-
TheOldHokie replied to the thread L4400 fel not working.You should be good as long as the colors on the work ports match. Zivassume you have not disconnected those hoses any place else. Just...
-
TheOldHokie replied to the thread PowerBeyond M8200.Here is a Summit valve. The PB and work ports are SAE-08 and the P and T ports are SAE-10. Hose end adapters run about $3-$10 each...
-
-
TheOldHokie replied to the thread L4400 fel not working.None of thiz is adding up. You have flow and pressure but the loader and 3pt dont work. Swapping the hoses takes the 3pt and anything...
-
TheOldHokie replied to the thread L4400 fel not working.Lets recap: You measured 2600 PSI pressure at the loader inlet hose. You measured 8+ GPM flow at the loader inlet hose Yet with...
-
TheOldHokie replied to the thread L3902 HST - 3 point lift needs a small increase.All you need is s $10 gauge frim Amazon and an adapter fitting for the loader hose on your tractor. I https://a.co/d/87yObB7 Or fir a...
-
TheOldHokie reacted to North Idaho Wolfman's post in the thread L3902 HST - 3 point lift needs a small increase with
Like.
Buy a bigger tractor! -
TheOldHokie replied to the thread L3902 HST - 3 point lift needs a small increase.A word to the wise. Long heavy 3pt implements bouncing around on the 3pt break things. Be very careful about boosting pressure beyond...
-
TheOldHokie replied to the thread Front loader for a B7200.Thats at the pins. Dan
