Russell King's latest activity
-
RRussell King replied to the thread ZD326s Bogging Down Under Load.@JohnR68 If you have some sort of lift pump involved (tank mounted low) then that is probably failed. When tank is fuller there is...
-
RRussell King replied to the thread Identify this part.That looks sort of like part of a bearing cage (ball separation cage). There is a bearing behind that seal (size 6208?). The cage is...
-
-
RRussell King reacted to Mikec575's post in the thread M7040 3 point weakens throughout the day with
Like.
Yes sir that’s fine and I can get two short hoses made to fit the nipples on the tractor. -
RRussell King replied to the thread Kubota M5950DT No Start.There is a stop switch (#60) involved on your tractor. I don’t know if that is attached to the injection pump but it usually is near...
-
-
RRussell King replied to the thread Fuel gauge and temperature gauges pegging to full fuel and hot after 45 - 60 minutes..You may be able to just run new wires from the sensors to the gauge instead of making a new harness. I don’t have a clue how either end...
-
RRussell King reacted to NorthwoodsLife's post in the thread What did you do to or on your Kubota today? with Like.
Thank you. I hope that you are right. I think I saw the spring retainer still on the rod It looks as though the boot is not torn. I...
-
RRussell King replied to the thread What did you do to or on your Kubota today?.Are you sure there is a failure in the boot? It looks intact in the picture and just locate improperly and missing the wire spring that...
-
RRussell King reacted to retiree-urgency abandoned's post in the thread Attachment Hydraulic Hose Pressure Relief with Like.
Sorry for the delayed update - got sidetracked on some other things. Had some parts in my parts jar and picked up the rest from the...
-
RRussell King reacted to R Riggott's post in the thread Leaky Quick Disconnect BX23 LA210-1. O-ring Replacement vs QD Coupling Replacement (with O-ring Part Number) with Like.
My BX23MLB recently developed a slow seep at the Snap-Tite Series 72 Quick Disconnects on the LA210-1 Loader control valve to the 1/4"...
-
RRussell King replied to the thread B7100HST - D ... First time owner assistance.Sorry I was possibly incorrect in my statement. There are a few versions of “B7100HST” that you can look at illustrated parts lists of...
-
RRussell King replied to the thread B7100HST - D ... First time owner assistance.I think there are a few gears AND a high/low range.
-
RRussell King replied to the thread Removing front axle assembly on L275.Why do you want to remove the whole axle? You can probably get the wheel off and get to that seal by taking the housing apart. I...
-
RAfter using the tractor several times, the wood shim and duct tape on the bottom of the seat is still working. Time to rework the...
-
RRussell King replied to the thread 2023 LX3310 3 point hitch operating range..@Bonj The illustrated parts list shows the feedback rod (#30) on the rear right hand side. It should be attached to a tab that will...
-
-
RRussell King replied to the thread 2023 LX3310 3 point hitch operating range..There is an adjustment for that called the feed back rod. See this thread for instructions on a couple of different age tractors...
