Russell King's latest activity
-
RRussell King reacted to WillyBill's post in the thread 3 point Unverferth Rolling Basket Harrow with
Like.
Update on my 3 pt Unverferth rolling basket harrow project. I started with a 4 row Brillion cultivator, removed the cultivator gangs and... -
RRussell King replied to the thread My Big Lawn Mower!.Ospho is a brand name not an acronym. Here is a link to their site. There are other similar products. https://www.ospho.com/
-
RThere are no NPT ports on that valve. Everything is SAE oring boss - DO NOT USE SEALANT. Dan
-
RRussell King replied to the thread Hydraulic Controller.Other suggestions are to be sure you label the hose ends as you remove them one by one or you will have a mess to figure out. Tie the...
-
RRussell King replied to the thread Hydraulic Controller.If you can post the valve model number for both valves or better yet identify the ports on each valve with a better description than...
-
RRussell King replied to the thread Kubota L3250: Huge oil spill from behind the engine mounting..Assuming the plug with plunger is in the bottom of the clutch area of the transmission case, that is a drain for whatever gets into the...
-
RRussell King reacted to Selkirk_D's post in the thread Just about ready to give her a workout! with Like.
So the guys wrapped up yesterday afternoon. This is where I take over and install garage doors and finish out the inside. I’m super...
-
RRussell King replied to the thread Bradco 715 front blade attachment.The orange thing is not a knob as far as I can tell. That looks like a fill or a vent. The label shows what the lowering speed knob...
-
ROther worn parts were discovered along the way
-
RRussell King replied to the thread L2800 HST PTO Troubles.Replacing that pin and engaging plate should tighten that up quite a bit. It is interesting they modified the holes to slots in that...
-
RThanks. I was hoping it would work as opposed to setting up a PTO pump and reservoir system. I already have the hydraulic block outlet...
-
RThanks Russell - I think I found it....eventually. I'm a bit slow at this stuff.
-
RRussell King replied to the thread Searching question.There is also an advanced search option that can be used to gain some more control over the search.
-
RRussell King replied to the thread Key option.Looks like it originally had a key switch. But older Kubotas did use a knob switch for glow plugs and starter after a key switch.
-
