Paul Allwood's latest activity
-
The B7200 outlet block relief specification is 2060 PSI. The B7200 3pt lift is rated for 400 pounds max at the pins. The B1630 loader... -
I will have to look at my msnuals. The lower relief pressure absolutely lowers the 3pt lift capacity. I have no idea why that was...
-
Paul Allwood replied to the thread Front loader for a B7200.Any idea why the relief pressure would be specified at 1450 psi in the B1630 loader manual ? Was there something different about this...
-
I would set it higher that the tractor. Dan
-
Paul Allwood replied to the thread Front loader for a B7200.Only because the specified relief setting for the loader in the B1630/1640/1640A loader manual is 1450 psi when fitted to the B7200HSTD...
-
Paul Allwood replied to the thread B7200 running hot.Thanks Hugo
-
Hello Paul, You can measure the sensor resistance with a know good thermometer in a pot of water on a stove at around 80°C. And check...
-
Paul Allwood replied to the thread B7200 running hot.I fitted the temp sensor into a new bush today that got the sensor further out of the bush into the water. The Bush is a M16 x 1.5 - 1/8...
-
-
Paul Allwood replied to the thread Front loader for a B7200.More pressures and power beyond now works. The fitting for the power beyond port of the loader valve arrived, and the power beyond...
-
-
Well, Paul, time to get started on the backhoe ... :giggle:
-
Paul Allwood replied to the thread B7200 easier steering.Thanks. I don't have anything on the back of the tractor yet, and hasn't considered it's effect on reducing steering effort.
-
Hi Paul, what do you have on the rear of your tractor? I find a heavy counter weight effective to ease the steering.
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Dan
-
That is 100% normal. You have measured relief pressure by blocking off the open center (neutral) circuit. That puts a major load on the...
-
Paul Allwood replied to the thread Front loader for a B7200.Picked up some fittings today and made a start on checking pressures this evening. I was interested to see that the engine was quite...
-
