Paul Allwood's latest activity
-
Here is the information on my bucket. I'm guessing it is similar to most others. The tractor was parked on my bridge, one place that's... -
The videos works for me now:) I'll check the range of motion on mine and get back to you. It appears yours currently moves slightly in...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Chim
-
Paul Allwood replied to the thread Front loader for a B7200.I think I'm going to need to slightly adjust the location of the centre bracket holes for the end of the dump cylinder to slightly...
-
Paul Allwood replied to the thread Front loader for a B7200.Strewth - I think I've made it public. Does that work ?
-
Paul Allwood replied to the thread Front loader for a B7200.The beginnings of my SSQA....hopefully this should show a video. https://youtube.com/shorts/fzP8wWgT5no?feature=shared
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks, I'll try it.
-
Can't say that I've seen any directly-posted videos. A common method of sharing videos is to post them on YouTube and link them. I...
-
Paul Allwood replied to the thread Front loader for a B7200.I tried to convert a video to a GIF of the beginnings of the SSQA bits moving between curl and dump. The response to the first effort...
-
Paul Allwood replied to the thread Front loader for a B7200.1 step back, then a couple of steps forwards. The bush I had welded into the bottom end of the right side loader arm was out of line...
-
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks again Chim, the pics are very helpful.
-
Here are a few more pictures showing the engagement on the factory bucket The round pin measures 1-1/4"Ø (at least on my "Merican" tape...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Chim - that makes sense
-
Comparing the round pin diameter to the dimensions of the slot can be a little deceiving. The pin (I can measure it but think its...
-
As TheOldHokie said, the drawing is minimal. The slot is 2" wide, so a 1-1/4 pin would give + or - 3/8" on engagement. My implements all...
