Paul Allwood's latest activity
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Dan -
If it isnt spec'd it can vary. Notice that drawing is very minimal. Dan
-
Paul Allwood replied to the thread Front loader for a B7200.I've found a couple of references that suggest the wedge pin diameter is typically 1.25". Does this sound right, or since it's dimension...
-
Paul Allwood replied to the thread Front loader for a B7200.Excellent, thanks. I had found a version of this drawing but it was so blurry that I couldn't read any of it.
-
Here's the drawing from the official spec. SAE J2513. I think the slots for the pins has varied some in the past.
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks for the info and the pics Chim - it's appreciated.
-
I have three that I measured this morning. Dimension "A" is 16" and Dimension "B" is 1-1/2". For the first project that required a...
-
Paul Allwood replied to the thread Front loader for a B7200.I'm hoping someone can help with some dimensions. My plan is to fabricate a standard SSQA attachment receiver for the front of the...
-
-
Paul Allwood replied to the thread Front loader for a B7200.Yeah, all good. I was interested too as I'm new to this stuff and have a lot to learn.
-
I think the port relief comment was aimed at me -- a way to limit the lifting force on my loader without affecting the pressure...
-
Paul Allwood replied to the thread Front loader for a B7200.Ok, thanks again. I do have a valve - 3 spool with float on the raise/lower spool. The 3rd spool is to allow for a 4 in 1 bucket or a...
-
Bounce from the longer lever arm acting on the tractor. Twitchier controls from the shorter lever arm acting on the boom. A port...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Dan. Some of the welds look ok, from a distance. Even better with a coat of paint.
-
IIRC a B1630 was rated fof ~500#. Unless you are going more than that I think you are more than safe. I wish I had your welding skills...
-
Paul Allwood replied to the thread Front loader for a B7200.I've never used or built one so I'm interested in what would contribute to bounce and being hard to control ? Also, what are port reliefs ?
